Shindaiwa DG1000MI manual Engine Side, Generator side

Page 39

Description

Engine Side

Clean each parts / tightening

Engine oil checks / add oil

Engine oil change (1st time at 50 hr mark)

Oil Filter change (1st time at 50 hr mark) Coolant level check / add coolant Exhaust color check

Coolant change

Drain excess water and sediments in the water separator

Drain water from fuel filter or replace

Drain water from fuel tank

Clean water separator and clean gauze filter in engine feed pump

Change filter in the magnet pump for air extraction in fuel line

Clean inside fuel tank

Leak check (fuel, oil, and coolant) Replacing fuel hose

Clean or replace air cleaner element

Battery fluid level check

Battery hydrometer check

Fan belt check

Radiator Flush Cleaning

Check and adjust engine valve clearance Compression check

Fuel injection nozzle check

Fuel injection timing check

Generator side

Various meter and alarm lamps check Operation check of earth leakage relay Grounding resistance check Insulation test

- 39 -

Startup	Every	Every	Every
check	200hrs	400hrs	500hrs



	◯		◯


	◯				◯		◯
			Clean				◯
			Clean				Replace
			◯
							◯
							Clean
	◯		◯				◯
			Clean				Replace
	◯						◯

							●
	◯				●



			◯
			◯

Every

1000hrs

or ◯2 yr.

Replace◯

●

or 1 yr.

●

Image 39

Contents DG1000MI Introduction Injuries Safety GuidelinesSuffocation from exhaust fume Electrical ShockBurns Injuries to eyes and skinExplosion FireInjuries Location of Warning labels Specification Matrix SpecificationsUse Parts Ambient ConditionExternal view Control panel Monitor Display EquipmentEngine Oil Monitoring Lamp for oil pressure low Injuries Hour Meter built into the Tachometer Battery Charge Monitoring Lamp charge lampWater Temperature Gauge GaugesFrequency Meter Fuel GaugeGenerator Gauges Amp MeterSwitch Starter Switch Panel Light / Pilot LampEmergency Stop button Voltage Regulator and Throttle Lever Amp Meter Changeover SwitchThermal Relay Earth Leakage Relay UnitFuel Line Changeover Valve 3-way valve Using fuel from built-in fuel tank＜＞ Transportation Transport and InstallationTransportation Lifting EquipmentInstallation ConnectionSelecting Cable Electrical damages Connecting Cable Load Connection Terminal Plate 3-Phase For 3-Phase LoadFor 1-Phase Load1 2 1-Phase Output Terminals & Receptacles For 1-Phase Load2Grounding Work Earth Leakage Relay and GroundingOperation Check Electrical Shock Fire Burns Initialization and pre-checkEarth leakage breaker relay has activated Electrical Shock InjuriesChecking Engine Oil Selecting proper engine oilEngine Oil Capacity Checking Coolant/water Checking Radiator / Adding waterChecking Coolant reservoir tank / Adding coolant Checking Fan Belt Coolant CapacityTension Condition Checking FuelChecking Fuel, Engine Oil, and Water leakage Checking BatteryReplacing the battery Initializing / preparation OperationFrequency Adjust Screw Damages to the property 200/400 Voltage Changeover Dual Voltage SystemDuring operation Refer to 7-2. Connecting cable Protection Features Feature List Stopping the Generator During Operation section Connecting to External Fuel TankMaintenance Generator side Engine SideReplace, refer to 8-1 Checking Engine Oil 10.1 Oil ChangeCleaning / Changing Air Filter Element Draining Water from Water Separator Cleaning / Changing Fuel FilterClean gauze filter in engine feed pump Clean gauze filter in water separatorIsuzu Part No 8970631550 Draining Water from Fuel Tank Long-term Storage Storage ProceduresStacking Troubleshooting Ask our distributor to repair Page Generator Wiring Diagram Engine Wiring Diagram