5.2.7.4 Thermal Relay
This relay sends the signal to the
Stop the engine.
① Open the control panel and push the reset button of the ②thermal relay.
You can recover the breaker to the ON position.
<Caution>
Do not change the preset value of the thermal relay.
Thermal Relay
5.2.7.5 Earth Leakage Relay Unit
Sensing the earth leakage current, the unit (relay) send a signal To the
to the terminals (loads).
(refer
5.2.7.6 Amp Meter Changeover Switch
Using this switch, the current between the phases (R.S.T) will be
displayed on the Amp meter.
5.2.8Voltage Regulator and Throttle Lever
5.2.8.1Voltage Regulator
The dial adjusts output voltage.
By turning the dial clockwise, an operator can increase the voltage.
By turning the dial
voltage.
- 15 -