North Star M1108D owner manual Splitting Operation, General safety information

Page 20

Splitting Operation

WARNING

Before starting this log splitter, review the following instructions and safety information for safe operation of the log splitter.

Failure to follow these rules may result in serious injury to the operator or bystanders from moving parts that crush, cut, or entangle from flying objects, burns, fire, falling or tripping, or from carbon monoxide poisoning.

General safety information:

•Read manual. Do not allow anyone to operate the log splitter who has not read the Owner’s Manual or has not been instructed on the safe use of the splitter. The log splitter owner should instruct all operators in safe log splitter operation.

•Age restrictions. Never allow anyone under 16 years old to operate the log splitter. Anyone 16 years and older must be trained and supervised by a trained adult.

•Intended use. Log splitters should only be used for splitting wood logs, lengthwise with the grain. Do not use for other purposes as unforeseen hazards may result.

•Modifications. Never modify or alter the log splitter in any way. Modifications can create serious safety hazards and will void the warranty:

•Attachments. Never add attachments to the splitter, except for authorized accessories supplied by the manufacturer with instructions for safe installation and use.

•Engine speed. The maximum engine speed is preset at a safe limit. Never attempt to modify the engine speed setting to run at a higher speed.

•Fuel/exhaust system. NEVER modify or add to the exhaust system, fuel tanks, or fuel lines. Fire can result.

•Remote control. NEVER attach a rope, cable, or other remote device to the splitting control.

•Splitting wedge. NEVER attempt to change the height or speed of the splitting wedge.

•Pressure setting. NEVER increase the pressure setting of the pump or control valve.

•Safety equipment / controls. Always operate the log splitter with all safety equipment in place and in good working order, and all controls properly adjusted for safe operation.

•Know how to stop. Be thoroughly familiar with all controls and with the proper use of the equipment. Know how to stop the log splitter and relieve system pressures quickly if needed.

•Operating speed. Always operate the log splitter at the manufacturer’s recommended speed. The maximum speed of the engine pump and wedge are preset within safe limits.

•Daylight only. Only use the log splitter in daylight so you can see what you are doing.

•Smoking / sparks. Never smoke while operating the log splitter, and never operate near sources of sparks or flames.

•Under the influence. Never operate, or let anyone else operate, the log splitter while under the influence of alcohol, drugs, or medication.

•Unattended. Never leave the machine unattended while the engine is running.

•Refueling. Never refuel the engine until it has cooled at least two minutes.

•Adjusting / repairing. Always make sure the engine is off before cleaning, repairing or adjusting the splitter, except as recommended by the manufacturer. In addition, disconnect the spark plug and move all control handles back and forth to relieve system pressure before changing or adjusting hydraulic system components such as hoses, tubing, fittings or other components.

•Replace labels. Always make sure safety labels are in place and in good condition. If a safety label is missing or not legible, order new labels because unsafe operation can result. Call 1-800-270-0810 to order new safety labels.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents M1108D Hazard Signal Word Definitions Table of Contents Warranty Registration About Your Log SplitterThis equipment to others About Your Log SplitterSafety Label Locations Split Control Lever Operation Machine Component Identification DescriptionInitial Set-Up Wear between the keepers and beam Way Wedge Wings Wing Assembly Optional 4-Way Wedge WingsImportant Make sure log splitter engine is off Moving and Towing to the Job SiteMoving the log splitter Attach log splitter to vehicle hitch TowingPut front outrigger leg Important safety instructions Before Each Use-Inspection / Maintenance Step One Inspect and maintain log splitter before each useRemove debris from engine, muffler, and moving parts Check fuel tank and fuel lines for leaksHydraulic system Check the hydraulic system carefully Before Each Use-Inspection / Maintenance Add gasoline Before Each Use FuelingRemove gas cap Remove engine gas cap Fire precautions Before Each Use Work Site Selection & Set-UpStep Three Work site selection and log splitter set-up Select locationLock both the outrigger legs in the Down position Lock both outrigger legsBlock wheels Apply grease General safety information Splitting OperationSet to HorizontalOr vertical ClothingFingers or cause damage to the splitter Lock rear outrigger leg in down positionVertical position Load log Correct Log OrientationExtend wedge Stop wedgeReturn wedge Remove split wood After useRemove split wood from area Turn off engine Remove engine debrisStorage Short-Term StoragePeriodic Maintenance As specified in spark arrestor muffler manual Troubleshooting Any Questions, Comments, Problems or Parts OrdersSpecifications Parts Breakdown Exploded View 1108, 1109, 1114 Rev D ALL Summary of Important Safety Information for Operation Personal protective equipment Safety Before Use Read/instructSafety During Inspection/Maintenance Safety During Fueling Safety in Work Site SelectionLoading/Unloading Safety During Use General Safety During UseSafety in Loading, Operating, and Unloading Safety After use Assembly Instructions Assembly Instructions Step Bolt Catch Pin Towbar Outrigger Leg Fasten Horizontal Beam Lock to 1114 models only Tighten Idle Control Bolts to 20 lb- ft with a wrench Return Line

M1108D specifications

The North Star M1108D is a versatile and advanced military vehicle designed to meet the rigorous demands of modern warfare. Known for its robustness and adaptability, the M1108D has been developed with state-of-the-art technologies and features that enhance its performance in diverse environments.

One of the standout features of the M1108D is its powerful drivetrain, equipped with a dependable turbocharged engine that delivers impressive horsepower and torque. This ensures the vehicle can traverse challenging terrains, whether urban landscapes or rugged off-road conditions, making it a reliable option for military operations.

The M1108D boasts an independent suspension system, providing excellent ride quality and stability, especially when navigating difficult ground surfaces. This system allows for improved handling, reducing the wear and tear on the vehicle while enhancing crew comfort during long missions.

In terms of protection, the vehicle is designed with advanced armor plating that offers a high level of ballistic and blast protection for its occupants. This ensures that personnel inside can operate with greater confidence, knowing they are shielded from potential threats. Additionally, the M1108D is equipped with upgraded defensive technologies such as smoke grenade launchers and jamming systems, further enhancing its survivability on the battlefield.

Another critical characteristic of the M1108D is its modular design, allowing for easy customization and adaptation. It can be configured for various roles, including troop transport, command and control, medical evacuation, or as a platform for weapon systems. This versatility makes it an ideal choice for diverse military operations.

The vehicle also integrates modern communication and navigation technologies, facilitating real-time coordination and situational awareness. These systems enhance operational effectiveness, allowing units to respond quickly and efficiently to evolving battlefield conditions.

Fuel efficiency is an essential aspect of the M1108D, as its engineering incorporates features that optimize consumption without compromising performance. This attribute extends operational range, ensuring that missions can be conducted with fewer logistical challenges.

Overall, the North Star M1108D exemplifies modern military vehicle design, combining durability, versatility, and advanced technological integration. Its myriad features make it a vital asset for armed forces, capable of adapting to the unpredictable nature of contemporary combat scenarios. As militaries around the world continue to evolve, the M1108D stands out as a reliable and effective solution for a range of operational needs.
Top Page Image Contents