North Star M1108D owner manual Summary of Important Safety Information for Operation

Page 33

Summary of Important Safety Information for Operation

WARNING

Carefully read and make sure you understand the following safety information before using the log splitter.

Improper use or maintenance of the log splitter can result in serious injury to the operator or bystanders from moving parts that can crush or cut, flying objects, burns, fire or explosion, escaping high pressure hydraulic fluid, or carbon monoxide poisoning.

Introduction

●Read Manual. Read this operator’s manual and the engine Owner’s Manual completely before attempting to use the log splitter. Serious injury or death can result if safety instructions are not followed.

●Instruct operators. The log splitter owner should instruct all operators in safe log splitter operation.

●Intended use. Log splitters should only be used for splitting wood logs, lengthwise with the grain. Do not use for other purposes, as unforeseen hazards may result.

Prohibition Against Modifications

Never modify or alter the log splitter in any way. Modifications can create serious safety hazards and will void the warranty.

●Attachments. Never add attachments to the splitter, except for authorized accessories supplied by the manufacturer with instructions for safe installation and use.

●Engine Speed. The maximum engine speed is preset at a safe limit. Never attempt to modify the engine speed setting to run at a higher speed.

●Fuel/Exhaust system. NEVER modify or add to the exhaust system, fuel tanks, or fuel lines. Fire can result.

●Remote Control. NEVER attach a rope, cable, or other remote device to the splitting control.

●Splitting Wedge. NEVER attempt to change the height or speed of the splitting wedge.

●Pressure Setting. NEVER increase the pressure setting of the pump or control valve.

Operator Restrictions

●Untrained Operators. Do not allow anyone to operate the log splitter who has not read the owner’s manual or been instructed on the safe use of the splitter.

●Minimum Operator Age. Never allow anyone under age 16 to operate the log splitter. Anyone 16 years of age and older must be trained and supervised by a trained adult.

Safety in Moving and Towing the Log Splitter

WARNING

The log splitter is very heavy. It can cause serious injury if it rolls out of control or tips over.

Follow the safety instructions below for safely moving the log splitter.

General safety while Moving

●Horizontal position. Make sure the log splitter is secured in the horizontal position before moving the log splitter. DO NOT move the log splitter when it is in the vertical position because it will be unstable and could tip.

●Hills. Do not move the log splitter up or down hills by hand – use a towing vehicle.

●Engine off. Never move the log splitter with its engine running.

●No riding. Never allow anyone to sit or ride on the log splitter.

●No cargo. Never transport cargo or wood on the log splitter.

Safety During Towing

●Read instructions. Review towing safety instructions in your towing vehicle manual.

●Securely attached. Be sure the log splitter is securely attached to the towing vehicle before towing.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents M1108D Hazard Signal Word Definitions Table of Contents About Your Log Splitter Warranty RegistrationThis equipment to others About Your Log SplitterSafety Label Locations Split Control Lever Operation Description Machine Component IdentificationInitial Set-Up Wear between the keepers and beam Optional 4-Way Wedge Wings Way Wedge Wings Wing AssemblyMoving and Towing to the Job Site Moving the log splitterImportant Make sure log splitter engine is off Towing Put front outrigger legAttach log splitter to vehicle hitch Important safety instructions Step One Inspect and maintain log splitter before each use Before Each Use-Inspection / MaintenanceRemove debris from engine, muffler, and moving parts Check fuel tank and fuel lines for leaksHydraulic system Check the hydraulic system carefully Before Each Use-Inspection / Maintenance Before Each Use Fueling Remove gas cap Remove engine gas capAdd gasoline Before Each Use Work Site Selection & Set-Up Fire precautionsStep Three Work site selection and log splitter set-up Select locationLock both outrigger legs Block wheels Apply greaseLock both the outrigger legs in the Down position Splitting Operation General safety informationHorizontal Set toOr vertical ClothingLock rear outrigger leg in down position Vertical positionFingers or cause damage to the splitter Correct Log Orientation Load logStop wedge Extend wedgeRemove split wood After use Return wedgeRemove split wood from area Turn off engine Remove engine debrisShort-Term Storage StoragePeriodic Maintenance As specified in spark arrestor muffler manual Any Questions, Comments, Problems or Parts Orders TroubleshootingSpecifications Parts Breakdown Exploded View 1108, 1109, 1114 Rev D ALL Summary of Important Safety Information for Operation Safety Before Use Read/instruct Safety During Inspection/MaintenancePersonal protective equipment Safety in Work Site Selection Safety During FuelingSafety During Use General Safety During Use Safety in Loading, Operating, and UnloadingLoading/Unloading Safety After use Assembly Instructions Assembly Instructions Step Bolt Catch Pin Towbar Outrigger Leg Fasten Horizontal Beam Lock to 1114 models only Tighten Idle Control Bolts to 20 lb- ft with a wrench Return Line

M1108D specifications

The North Star M1108D is a versatile and advanced military vehicle designed to meet the rigorous demands of modern warfare. Known for its robustness and adaptability, the M1108D has been developed with state-of-the-art technologies and features that enhance its performance in diverse environments.

One of the standout features of the M1108D is its powerful drivetrain, equipped with a dependable turbocharged engine that delivers impressive horsepower and torque. This ensures the vehicle can traverse challenging terrains, whether urban landscapes or rugged off-road conditions, making it a reliable option for military operations.

The M1108D boasts an independent suspension system, providing excellent ride quality and stability, especially when navigating difficult ground surfaces. This system allows for improved handling, reducing the wear and tear on the vehicle while enhancing crew comfort during long missions.

In terms of protection, the vehicle is designed with advanced armor plating that offers a high level of ballistic and blast protection for its occupants. This ensures that personnel inside can operate with greater confidence, knowing they are shielded from potential threats. Additionally, the M1108D is equipped with upgraded defensive technologies such as smoke grenade launchers and jamming systems, further enhancing its survivability on the battlefield.

Another critical characteristic of the M1108D is its modular design, allowing for easy customization and adaptation. It can be configured for various roles, including troop transport, command and control, medical evacuation, or as a platform for weapon systems. This versatility makes it an ideal choice for diverse military operations.

The vehicle also integrates modern communication and navigation technologies, facilitating real-time coordination and situational awareness. These systems enhance operational effectiveness, allowing units to respond quickly and efficiently to evolving battlefield conditions.

Fuel efficiency is an essential aspect of the M1108D, as its engineering incorporates features that optimize consumption without compromising performance. This attribute extends operational range, ensuring that missions can be conducted with fewer logistical challenges.

Overall, the North Star M1108D exemplifies modern military vehicle design, combining durability, versatility, and advanced technological integration. Its myriad features make it a vital asset for armed forces, capable of adapting to the unpredictable nature of contemporary combat scenarios. As militaries around the world continue to evolve, the M1108D stands out as a reliable and effective solution for a range of operational needs.
Top Page Image Contents