MQ PS4030 SAW — RULES FOR SAFE OPERATION
■ALWAYS keep the work area well organized.
■Keep the saw clean. It will perform better and last longer.
■ALWAYS Clear the cutting area of any debris, tools, etc.that would constitute a hazard while the saw is in operation.
■NEVERtouchthehotexhaustmanifold,muffler or cylinder. Allow these parts to cool before servicing the saw. Contact with hot! components can cause serious burns.
WARNING
ALWAYS check to make sure that the cutting area is clear before starting the engine.
■Keep all inexperienced and unauthorized people clear of the cutting area when operating the saw.
■No one other than the operator is to be in the working area when the saw is in operation.
■NEVER allow passengers or riders on the saw during operation or transportation.
■ALWAYS check the saw for loosened hardware such as nuts and bolts before starting.
■NEVER run the engine without the air filter. Severe engine damage could occur. Service air cleaner at recommended service intervals to prevent engine damage.
■Make certain all protective guards are securely in place BEFORE operating the saw.This saw is supplied with a blade guard, blade flange guard, and a belt guard.
■NEVER place your feet or hands inside the guards while starting or operating this equipment.
■DO NOT go near rotating parts, (blades, belts, pulleys or wheels), while engine is running.
■Moving Parts – Shut down the engine before performing service or maintenance functions. Contact with moving parts can cause serious injury.
DANGER
Pay close attention to ventilation when operating the saw in confined spaces such as tunnels, buildings or similar areas.The engine exhaust contains harmful elements. Ensure proper air flow to move engine exhaust away from the operator.
■Verify the engine start switch is set to the OFF position before installing a blade.
■Use proper blades and follow the blade manufacturer's recommendations. Match the blade RPM (Blade Shaft RPM) to the recommended blade surface feet per minute. (SFPM).
■Ensure the 5/8"
■NEVER leave the machine unattended while running.
■Ensure brakes are applied when leaving or when using on a slope. This saw utilizes a brake system where the brakes are automatically applied when the engine is stopped.
■Start engine with the Control Handle in the NEUTRAL position to prevent unexpected saw movement.
■Do not start engine on a sloping surface to prevent unexpected loss of control.
■DO NOT use on excessive slopes or on extremely uneven surfaces.
■If the saw must be parked on a slope and engine turned off, ensure the parking brake is engaged and holds the saw safely in place.Turning the saw across the angle of the slope will help prevent accidental downhill movement. Block the saw as well when leaving.
MQ PS4030 SAW • OPERATION MANUAL — REV. #0 (02/29/08) — PAGE 13