MQ PS4030 SAW — RULES FOR SAFE OPERATION
Saw Lifting and Loading Safety | Towing Safety Precautions (Trailer Usage) |
CAUTION
This Saw is very heavy. Use proper heavy lifting procedures and DO NOT attempt to lift the saw by the guards.
DANGER
NEVER stand under or allow anyone else to stand under the saw while it is being lifted.
■DO NOT use the handle bars and/or front pointer as lifting points.
■ALWAYS use ramps capable of supporting the weight of the saw and the operator to load and unload the saw. If the saw must be lifted, always use two people. Never attempt to lift the saw by yourself.
■NEVER tip the engine to extreme angles as it may cause oil to gravitate into the cylinder head making the engine start difficult.
■NEVER transport the saw to or from the job site with the blade mounted.
Transporting (Via truck/trailer)
■ALWAYS shutdown engine before transporting.
■Tighten fuel tank cap securely and close fuel petcock to prevent fuel from spilling.
■Drain fuel when transporting saw for long distances or over bad roads.
■Use appropriate lifting equipment to ensure the safe movement of the saw.
■Do not use the handlebars or front pointer as lifting points.
■When placing the saw on a
■Do not use the handlebars or front pointer as
■Never attempt to tow the saw untrailered behind a vehicle.
■Never transport the saw with the blade mounted.
■If the saw is being transported via a trailer, make sure the trailer complies with all local and state safety transportation laws. Refer to the following "Towing Safety Precautions" for basic towing techniques.
CAUTION
Conform to Department of Transportation (DOT) Safety Towing Regulations before transporting saw on public roads.
To reduce the possibility of an accident while transporting the saw on public roads, always make sure the trailer that supports the saw and the towing vehicle are in good operating condition and both units are mechanically sound.
The following list of suggestions should be used when towing your saw:
■Check the tire air pressure on both towing vehicle and trailer. Refer to the tire manufacturer's recommended pressure. Also check the tire tread wear on both vehicles.
■Make sure the hitch and coupling of the towing vehicle are rated equal to, or greater than the trailer "gross vehicle weight rating" (GVWR) of 6,000 lbs.
■ALWAYS inspect the hitch and coupling for wear. NEVER tow a trailer with defective hitches, couplings, chains, etc.
■ALWAYS make sure the trailer is equipped with "Safety Chains " and ensure they are attached properly.
■ALWAYS make sure the vehicle and trailer directional, backup, brake, and trailer lights are connected and working
■DO NOT exceed the recommended highway speed when towing.
■Use
■Use the trailer's swivel jack to adjust the trailer height to a level position while parked.
■Avoid sudden stops and starts. This can cause the trailer to skid or
■Avoid sharp turns.
■Trailer should be adjusted to a level position at all times when towing.
■Raise and lock trailer wheel stand in the "UP" position when transporting.
■DOT requirements include the following:
Connect and test electric brake operation.
Secure portable power cables in cable tray with tie wraps.
MQ PS4030 SAW • OPERATION MANUAL — REV. #0 (02/29/08) — PAGE 15