MQ PS4030 SAW — CONTROLS AND INDICATORS
5 14
3
16 | 7 | 6 | 17 |
4
13
12
8
2
9 | 11 |
10
18
1
15
Figure 5. MQ PS4030 SAW Controls and Indicators
Figures 5 and 6 show the location of the controls, indicators and general maintenance parts. The function of each control, indicator or maintenance part is explained below:
1.FNR Handle – Use to engage the saw in a forward or backward direction. Push handle forward to move the saw forward; pull handle back to move saw backward.
2.Raise/Lower Switch – Use to lift or lower the front of the saw (and blade if installed).
3.Bladeshaft RPM – Indicates bladeshaft speed in revolutions per minute.
4.Throttle Control – Controls the speed of the engine.Turn knob
5.System Status – Allows operator to monitor engine and electrical functions.
6.Ignition Switch – With key inserted turn clockwise to start engine.
7.Light Switch – When activated, turns on light. Lights offer better visibility when working indoors.
8.Depth Indicator – Indicates relative depth of blade in surface.
9.Handlebar Adjust – Loosen to move handlebar in or out.
10.LeftWater FlowValve – Meters water supply.
11.RightWater FlowValve – Opens and closes water supply to water supply system.
12.Water Pump Switch (Optional) – Toggle to turn pump on or off.
13.Emergency Stop Button – Press the RED Emergency Stop Button to shut the system down.
14.Socket Connector – Use to plug in optional light.
15.Depth Adjustment Knob – Use to adjust saw blade depth.
16.Auxiliary Switch –
17.Fuel Filler Cap – Remove this cap to add fuel.
18.Rear Access Panel – Remove to access items such as the battery, hydraulic filter, etc.
PAGE 20 — MQ PS4030 SAW • OPERATION MANUAL — REV. #0 (02/29/08)