DCA-400SSK — OUTPUTTERMINAL PANEL OVERVIEW
OUTPUT TERMINAL FAMILIARIZATION
The “Output Terminal Panel” is provided with the following:
zTwo 120V GFCI receptacles, 20 amp
zThree 120/240V output receptacles, 50 amp
zTwo 120V output receptacles, 20 amp (optional)
z3 Circuit Breakers 240V @50 amps
z2 GFCI Circuit Breakers 125V@ 20 amps
Control Box
The “Control Box” is provided with the following:
zMain Circuit Breaker 1000 amps
z
Output Terminal Panel
The Output Control Panel (See Figure 14) is located on the right hand side (left from control panel) of the generator. The UVWO lugs are protected by a face plate cover that can be secured in the close position by a pad lock. (See Figure 11).
FIGURE 11. Output Terminal Cover
120 Volt Recetacle
Two GFCI Duplex Nema
Pressing the reset button resets the receptacle after being tripped. Pressing the "Test Button" (See Figure 12) in the center of this receptacle will check the GFCI function. The receptacle should be tested at least once a month.
FIGURE 12. GFCI Test Button
Connecting Load
Loads can be connected to the generator by the UVWO Lugs or the convenience receptacles. (See figure 13). Make sure to read the operation manual before attempting to connect a load to the generator.
FIGURE 13. Connecting Load
Circuit Breakers
To protect the generator from an overload, a
Maximum Output
The entire load connected to the UVWO Lugs, all four slots in the duplex receptacles, and the must not exceed 352 kW in standby or 320 in prime output.
Twist Lock Dual Voltage Receptacles
Three
Input Receptacles
Two 120 volt, 20 amp input receptacles are provided to supply power to accessories, such as the battery charger (optional) or jacket water heater (optional).
PAGE 34 —