Multiquip DCA-400SSK Before Starting Engine, Before Starting Generator and Control Panel

Page 47

DCA-400SSK — GENERATOR START-UP PROCEDURE (MANUAL)

WARNING:

The engine's exhaust contains harmful emissions. ALWAYS ventilate the exhaust when operating inside tunnels, excavations or buildings. Direct exhaust away from nearby personnel.

Before Starting

Engine

1.Check the lubricating oil level prior to starting the engine. Make sure the generator is level. The oil level must be maintained between two notches on the dipstick.

2.When there is not enough lubricating oil, fill the crankcase with high grade motor oil. Use a high quality detergent oil classified CC or higher (See Table 11 on page 43).

3.Check the coolant level in the radiator and subtank. Replenish with antifreeze as necessary. Always maintain the coolant level between the FULL and LOW markings on the coolant container. Be sure the radiator cap is fastened securely.

4.Check the fuel level on the fuel gauge. If fuel is low, fill the fuel tank with clean fresh unleaded automotive diesel. If diesel spillage occurs, completely wipe up the spilled fuel immediately.

Before Starting

Generator and Control Panel

CAUTION:

NEVER start the engine with the main,

GFCI or load circuit breakers in the ON

position.

1.Be sure to disconnect the electrical load and switch the main, load and G.F.C.I. circuit breakers (Figure 31) to the “OFF” position prior to starting the engine.

Jacket Water Heater and Internal Battery Charger 120 VAC Output Receptacles (OPTIONAL)

This generator is equipped with two 120 VAC, 20 amp output receptacles located on the output terminal panel, page 43, Figure 14.

The purpose of these receptacles is to provide power via commercial power to the jacket water heater and internal battery charger.

These receptacles will ONLY function when commercial power has been supplied to them (Figure 31). To apply commercial power to these receptacles, a power cord of adequate size will be required.

When using the generator in hot climates there is no reason to apply power to jacket water heater. However, if the generator will be used in cold climates it is always a good idea to apply power to the jacket water heater at all times.To apply power to the jacket water heater simply apply power to the jacket water heater receptacle via commercial power using an power cord of adequate size.

If the generator will be used daily, the battery should normally not require charging. If the generator will be idle (not used) for long periods of time, apply power to the battery charger receptacle via commercial power using an power cord of adequate size.

When connecting the generator to a isolation (transfer) switch, ALWAYS have power applied to the generator's internal battery charger. This will ensure that the engine will not fail due to a dead battery.

CAUTION:

ALWAYS have power applied to the generator's internal battery charger when connecting the generator to a isolation (transfer) switch. Remember before connecting this generator to any buildings electrical system, have a licensed electrician perform the installation of the transfer switch.

Figure 31. Main, GFCI and Load Circuit Breakers

DCA-400SSK — PARTS AND OPERATION MANUAL (STD)— REV. #3 (09/17/01) — PAGE 47

Image 47
Contents MQ Power DCA-400SSK DCA-400SSK2 Whisperwatttm Generator Page Heres HOW to GET Help Table of Contents Parts Ordering Procedures Earn Extra Discounts when You order by FAXRules for Safe Operation High Temperatures AllowRadiator Rules for Safe OperationLoading and Unloading Crane BatteryEmergencies Maintenance SafetyTransporting DCA-400SSK -TOWING Towing Safety PrecautionsExplanation of Chart DCA-400SSK TRAILER-SAFETY GuidelinesWidth DCA-400SSK -TRAILER-SPECIFICATIONSModel Coupler Tires Wheels Axle Hubs Suspension Electrical Electric Brakes Electric Brake AdjustmentBrakes Hydraulic/Air/Surge Brakes DCA-400SSK -TRAILER Safety GuidelinesSuspension Tires/Wheels/Lug NutsTire Wear/Inflation Lug Nut Torque Requirements Torque Ft.-LbsDCA-400SSK -TRAILER-WIRING Diagram Symptom Possible Cause Solution DCA-400SSK -TRAILER-BRAKETROUBLESHOOTINGDCA-400SSK -TRAILER-BRAKETROUBLESHOOTING Machine Safety Decals DCA-400SSK Operation and Safety DecalsDCA-400SSK Operation and Safety Decals DCA-400SSK Specifications DCA-400SSK General Information JacketWater Heater Optional Battery ChargerEngine Electronic Governor SystemMajor Components DCA-400SSK Major ComponentsPage Dimensions Dry weight 4270kg 9413.64lb Wet weight 4800kg 10582.08 lbDCA-400SSK Dimensions Front and Rear Control Panel DCA-400SSK Control PanelPilot Lamp Indicates that the generator is working properly DCA-400SSK Control PanelDCA-400SSK Engine Operating Panel DCA-400SSK Engine Operating Panel Ignition Switch up to S/N3696509DCA-400SSK Outputterminal Panel Overview DCA-400SSK Outputterminal Panel Overview Maximum Amps Output Terminal Panel Available VoltagesOver Current Relay DCA-400SSK Outputterminal Panel Overview How to read the output terminal gaugesVoltage Change-over Board Single Phase, 240 VoltPhase, 240 Volt Single Phase, 139 VoltSingle Phase, 277 Volt Single Phase, 480 VoltPhase, 480 Volt Mounting DCA-400SSK InstallationOutdoor Installation Typical Generator Grounding Application DCA-400SSK InstallationExtension Cable DCA-400SSK PRE-SETUPGeneral Inspection Prior to Operation Coolant Lubrication OilFuel Fan Belt Tension Cleaning the RadiatorAir Cleaner Operation in Freezing WeatherPiping and Hose Connection Battery Cable InstallationWiring Three Phase Load Single Phase LoadBefore Starting Generator and Control Panel Before Starting EngineDCA-400SSK Generator START-UP Procedure KEY Switch Engine Ignition Switch Ammeter Load Auto Start-up Manual Start-upEmergency Stop DCA-400SSK Generator Shutdown ProcedureEngine Shutdown Page DCA-400SSK Maintenance Replacing fuel filter Check Electric Heater If equippedChanging Oil Generator Storage Cleaning breather elementGreasing Inspection / Maintenance DCA-400SSK Generator Wiring Diagram Page DCA-400SSK Engine Wiring Diagram KEY Switch DCA-400SSK Engine Wiring Diagram Controller DCA-400SSK -TROUBLESHOOTING Engine DCA-400SSK -TROUBLESHOOTING Engine Generator Troubleshooting DCA-400SSK -TROUBLESHOOTING GENERATOR/ENGINEDCA-400SSK -TROUBLESHOOTING Engine Controller Items Found In the Items Number Column Explanation of Code in Remarks ColumnQty Description DCA-400SSK Suggested Spare PartsDCA-400SSK Generator Assy Part Name QTY DCA-400SSK Generator Assy COVER, Bearing DCA-400SSK Control BOX Assy Part Name QTY Remarks DCA-400SSK Control BOX AssyDCA-400SSK Control BOX Assy RA20A2SE102BJ 2W 1K OHM DCA-400SSK Engine & Radiator Assy Dust Sensor DCA-400SSK Engine & Radiator Assy DCA-400SSK Engine & Radiator Assy UP to S/N 3701677~ DCA-400SSKENGINE Operating Panel AssyDCA-400SSK Engine Operating Panel Assy DCA-400SSK Outputterminal Assy DCA-400SSK Output Terminal Assy DCA-400SSK Battery Assy Battery DCA-400SSK Actuator Assy DYNC11020300024 DCA-400SSK Muffler Assy Muffler DCA-400SSK Fuel Tank Assy Fuel Tank DCA-400SSK Enclosure #1 Assy Floor Panel DCA-400SSK Enclosure #1 Assy Filler Bracket Enclosure #2 Assy DCA-400SSK Enclosure #2 AssyRear Frame DCA-400SSK Enclosure #2 Assy COVER, Roof Panel Enclosure #3 Assy DCA-400SSK Enclosure #3 AssySide Panel DCA-400SSK Enclosure #3 Assy 0845046904 DCA-400SSK Rubber Seal Assy Rubber Seal Assy DCA-400SSK OIL Piping Assy Pump N3701677~ DCA-400SSK Name Plate and DecalsControl BOX Group Bonnet Group Battery Group Engine and Radiator Group Output Terminal Group DCA-400SSK Name Plate and DecalsEffective July 1 Page Mail mq@multiquip.com WWW multiquip.com

DCA-400SSK specifications

The Multiquip DCA-400SSK is a robust solution designed for a variety of construction and developmental applications. Known for its reliability and efficiency, this three-phase diesel generator is equipped with a powerful engine that offers dependable performance in the field.

One of the standout features of the DCA-400SSK is its 400 kW output capacity, making it an ideal choice for large-scale operations where consistent power supply is crucial. It is powered by a high-performance, durable diesel engine that meets stringent emissions standards, ensuring compliance while delivering high efficiency.

The DCA-400SSK comes equipped with advanced technology that enhances its usability and performance. Its automatic voltage regulation (AVR) system ensures stable voltage under varying load conditions, which is essential for sensitive electrical equipment. This feature provides peace of mind to operators, knowing that their equipment is protected from voltage fluctuations.

Built with a sound-attenuated enclosure, the DCA-400SSK is designed to minimize noise, making it suitable for operation in noise-sensitive environments. This aspect not only protects the hearing of those working nearby but also ensures compliance with local noise regulations, thereby promoting a safer working environment.

Another remarkable characteristic of the DCA-400SSK is its user-friendly control panel, which features easy-to-read gauges and straightforward controls. This makes monitoring and operating the generator simple, even for those with limited experience in generator operation. With remote start capabilities, users can start and stop the generator from a distance, enhancing efficiency and convenience.

In terms of mobility, the DCA-400SSK is designed with integrated lifting points and forklift pockets, which facilitate easy transport around job sites. Its rugged construction ensures durability, able to withstand the harsh conditions typical of construction sites while maintaining optimal performance.

Overall, the Multiquip DCA-400SSK stands as a reliable and efficient diesel generator, combining powerful output with advanced features and environmental considerations. It is tailored to meet the demands of contractors and operators looking for a versatile and sturdy power solution. Whether for temporary power needs or long-term projects, the DCA-400SSK delivers exceptional performance in a compact and user-friendly package.