Desa EL-7 14-inch Storage, Replacement Parts, Filing Cutter Depth Gauges, Replacing Saw Chain

¨

ELECTRIC CHAIN SAW

CLEANING AND MAINTENANCE

Continued

Filing Cutter Depth Gauges

The cutter depth gauge clearance is reduced as cutters are sharpened. After every second or third sharpening, reset cutter depth gauges.

1.Place depth gauge tool firmly across top of two cutters. Make sure depth gauge enters slot in depth gauge tool (see Fig- ure 21).

2.Use medium flat file. File depth gauge level with depth gauge tool.

3.Remove depth gauge tool. With flat file, round off front corner of cutter depth gauge (see Figure 22).

Depth Gauge

Flat File

Depth

Gauge

Slot

Depth Gauge

Tool

Figure 21 - Depth Gauge Tool On Chain

Front Corner

Replacing Saw Chain

Replace chain when cutters are too worn to sharpen or when chain breaks. Only use re- placement chain noted in this manual. Al- ways include new drive sprocket when re- placing chain. This will maintain proper driving of chain. Note: For proper chain and drive sprocket, see Replacement Parts.

STORAGE

If storing saw for more than 30 days, fol- low steps below.

1.Drain oil tank.

2.Remove and clean guide bar and chain. Clean guide bar and chain by soaking in petroleum based solvent or mild soap and water mixture.

3.Dry guide bar and chain.

4.Place chain in container filled with oil. This will prevent rust.

5.Wipe a thin coating of oil over surface of guide bar.

6.Wipe off outside of saw body. Do this with soft cloth dampened with a mild soap and water mixture.

7.Store chain saw

•in a high or locked place, out of children’s reach

•in a dry place

•in a carrying case or with scabbard over guide bar

•with oil cap tight and saw upside down to prevent excess oil seepage

REPLACEMENT PARTS

WARNING: Use only replace- ment parts described in this manual. Use of other parts could damage saw or injure operator.

Purchase these parts from your local dealer.

Part

Number Description

EL-7

097572-03S Guide bar, 40,6 cm (16")

091375-02S Chain, 40,6 cm (16")

EL-7

097570-01S Guide bar, 35,5 cm (14")

091374-02S Chain, 35,5 cm (14")

LNT-3

097568-02S Guide bar, 30,5 cm (12")

091373S Chain, 30,5 cm (12")

LNT-3

097567-01S Guide bar, 25,4 cm (10")

091371S Chain, 25,4 cm (10")

LNT-2

097567-01S Guide bar, 25,4 cm (10")

091371-02S Chain, 25,4 cm (10")

104302-01S* Guide bar, 20,3 cm (8")

104301S Chain, 20,3 cm (8")

*When ordering replacement Guide Bar 104302-01S you must also order replace- ment Chain 104301S.

	PoleSaw
	104302-01S	Guide bar, 20,3 cm (8")
	104301S	Chain, 20,3 cm (8")
	General
Figure 22 - Round Off Front Corner Of	107713-01	Drive sprocket
	079417-03	Wrench/Screwdriver
Depth Gauge

After several hand filings, have authorized service center or sharpening service machine sharpen chain. This will insure even filing.

For more information, visit www.desatech.com 14 105020