Casablanca Fan Company C31UxxZ owner manual In the wall bezel replacement, Figure #1, Figure #2

Page 32
In the wall bezel replacement

® 3

In the wall bezel replacement

WALL CONTROL AND Hardware (not to scale)

Switch Mounting

Screws (2)

W-84

Switch Bezels

 

 

Wall Plate Screws (4) Wire Cap

White Wall

Almond Wall

(2) White

Wall Control

(1) White

(2) Almond

 

(1) Almond

Plate(1)

Plate(1)

 

 

 

 

 

 

Warning!

To avoid possible electrical shock, make cer- tain that electricity is turned off at the circuit breaker or fuse box before attempting any in- stallation or repair procedure

CAUTION! NOT turning the power OFF at the circuit breaker or fuse box may cause damage to the electronics within the wall control and/ or the PC board on the fan.

SCREWS

(2)

White Wall

W-84 Wall Control Bezel Replacement installation as follows - (In the Wall Replacement):

Figure #1

Step 1a. Locate the two (2) screws holding the switch plate to the wall control and remove the cover plate as shown in Figure #1.

Step 1a. Locate the four (4) tabs holding the bezel to the front of the switch, then press in on each tab one at a time, removing the bezel as shown in Figure #2.

Step 1b. Locate the rubber key pad attached to the four (4) locating pins as shown in Figure #2 and remove rubber key pad from the WHITE bezel, also as shown in Figure #2.

BEZEL

BEZEL TABS

Figure #2

30

Image 32
Contents PN C3143001-AT0209 HollistonC31UxxZ O W N E R ’ S M A N U A LTHIS WARRANTY SUPERSEDES ALL HollistonPREVIOUS WARRANTIES Proof of PurchaseLIMITED WARRANTY CONTENTS HollistonRead and Save These Instructions PN C3143001 AT0608SERIAL No. DJ06 MODEL # C31UxxZHolliston TYPEUplight Bulbs Parts Guide7-Watt Incandescent Blade Iron Screws pre-installed, see pg 13, step 9a Adaptor AssemblySwitch Housing Cap Switch Housing Cap Screws 8-32 x 3/8For best performance and for your warranty to be valid use only genuine Casablanca blades, light fixtures, and accessoriesIntroduction Before You Start Safe Usesloped ceiling installations When to Use Extension PolesMOUNTING RECOMMENDATIONS General Guidelines Calculation of Ceiling AngleFan Installation Getting Started Ceiling plate InstallationInstalling a New Ceiling Fixture Outlet Box Using Existing Ceiling Fixture Outlet BoxCANOPY LOCK WASHERS CANOPY SCREWS Lag Screw InstallationCanopy Installation IMPORTANT SAFETY INFORMATION Prepare for fan installation as followsFan Preparation Figure #1 Figure #2Figure #5 Fan Preparation - continuedFigure #4 LIGHTBULB INSTALLATION uplight Install LightbulbsHanging the Fan Figure #6Figure #2 Canopy Hatch and cover ring InstallationCanopy Electrical Connections Attach Blade Irons Blade InstallationBlade Installation LIGHT FIXTURE Installation optional Blade Installation ContinuedBlade screws must be tightened securely before operating the fanLight Kit Adaptor Disassembly switch housing and end cap InstallationNO LIGHT KIT - Installation Switch Housing and Light Kit Adaptor Installation - NO LIGHT KIT Switch Housing and Light Kit Adaptor Installation - Continued NO LIGHT KITAdaptor Installation NO LIGHT KIT - END SCREW Figure #6LIGHT KIT - Installation Figure #9 Switch Housing and Light KitAdaptor Installation - Continued LIGHT KIT Figure #10 Figure #11Figure #12 Figure #14Figure #17 Figure #15Figure #16 W-84 WALL CONTROL INSTALLATION Prepare for W-84 Wall Control Bezel replacement as followsW-84 Wall control Preparation For use on product with BOTH UP and DOWN LIGHTS ONLYPrepare for W-84 Wall Control installation - Continued PINSRUBBER KEY PAD ALMONDW-84 Wall Control w-84 Control INSTALLATION Installing the W-84 Wall Controlsingle W-84 Installation NEUTRAL dual W-84 InstallationDIP SWITCHES Operation Power Make sure where you are in the sequence to the rightOperation Speed Control Operation Reversing Airflowchanging frequency setting To dim just the up lightTo dim just the down light NOTE All fans leave the factory set to “1111”Automatic Demonstration Program ++++Operation Safe-Exit and light-minder Program To enter the demonstration program+ + + Operation Home-Safe ProgramOperation Fan-Minder Program In the wall bezel replacement W-84 Wall Control Bezel replacement CONTINUED ALMOND WALL PLATE SCREWS ALMOND COLORED WALL PLATE BEZEL BEZEL TABS BEZEL ALIGNMENT PIN AND HOLEALMOND COLORED BEZEL Troubleshooting tips Product Specifications DimensionsWeight Care RecommendationsHolliston