Casablanca Fan Company C31UxxZ LIGHT KIT - Installation, switch housing and end cap Installation

switch housing and end cap Installation

LIGHT KIT - Installation:

NOTE: If you are installing your fan with a light kit attached as below in Figure #1, continue with these installation instruction Step 13a. Also you will need the installation instructions that came with your new light kit to complete the installation of the fan.

Figure #1

Switch Housing Hardware (not to scale)

	Switch Housing
	Cap
Light Kit	Switch Housing
Adaptor Assembly	Cap Screw (2)
	8-32 x 3/8

Step 13a. Locate the light kit adaptor assembly and screw plug as shown in the switch housing hardware section above. You will need to disassemble and use parts from the light kit adaptor assembly for adding a light kit to your fan.

Do not discard screws during disassembly, all screws will be needed for other installation steps within this document.

Light Kit Adaptor Disassembly

Step 13b. Locate and remove the #8-32 screw that is attaching the bottom cap to the light kit adaptor assembly as shown in Figure #3 and remove the bottom cap. Do not discard screws during disassembly.

Step 13c. Locate and remove the four (4) #6-32 screws from the cap as shown in Figure #4 and remove the cap. Do not discard screws during disassembly.

NOTE: Locate the light kit adaptor as shown in Figure #5, this adaptor plate will need to be attached to the fan during fan installation, installation instructions continued on the next page of this document.

SCREW PLUG	SCREW
	#8-32
BOTTOM CAP	SCREW
	#6-32

CAP

LIGHT KIT

ADAPTOR

Figure #2

BOTTOM CAP

SCREW , #8-32

BOTTOM CAP

Figure #3

CAP

Cap SCREW,
#6-32	Figure #4
(Screws 4)

LIGHT KIT

ADAPTOR

Figure #5

18