Casablanca Fan Company C31UxxZ owner manual dual W-84 Installation, Neutral, Dip Switches

®3

dual W-84 Installation

To control the fan and lights from two locations (a three-way circuit), use two W-84 wall controls as shown in the wiring diagram in Figure #1. Before installing the two switches into the wall, place both switches side by side, then locate the 4 dip switches on the side of the two switches as shown in Figure #2. Then make sure that the dip switches are set to the same address on both switches as shown in Figure #2. When setting these dip switches you are setting the channel number that is required to control both your fan and lights from both sides of the room. If you are installing other Inteli-Touch®3 fans within your home you may need to reset the dip switches on these other fans to a different channel before installing your W-84 wall control into the wall. Please review the section on channel changing within this part of the operation manual as shown on page #27.

CAUTION!

DIP SWITCHES

(FIGURE #2)

Ensure power is turned OFF at the breaker or fuse panel before starting installation.

NEUTRAL

WHITE

GREEN BLACK

BLACK

	BLACK WITH
	WHITE STRIPE
GREEN	GREEN
W-84	W-84
RED
BLACK WITH
WHITE STRIPE
BLACK(FIGURE #1)	BLACK
RED	RED
BLACK	BLACK
	RED

T o c o n t r o l t h e f a n a n d l i g h t s f r o m t w o locations (a three - way circuit), use t w o W-84 wall controls.

1.Remove the screws and switch plate from the existing switch box and the screws holding the switch in the switch box.

2.Pull the existing switch from the switch box to expose the wire connections.

3.Determine which wire is connected to the common terminal from the power source (120V AC) of the three-way switch. (The terminal will be marked on switch).

120V AC

BLACK BLACK

4.Remove the wire from the common terminal of the three-way switch. Connect this wire to the remaining black/white striped wire on the W-84 control. Secure this splice with a wire nut.

5.Remove the two remaining wires from the three-way switch. Connect the black wire of these wires to a black wire on the W-84 control. Secure the splice with a wire nut. The remaining red wire is to be connected to the other red wire on the W-84. Secure the splice with a wire nut.

6.Connect the green ground wire coming from the back of the W-84 control to the ground wire in the switch box. Secure the splice with a wire nut.

7.Check your work by using the wiring diagrams as shown in Figures

#1 and #3 on this page.

8.Install the W-84 in the wall box with the two long screws provided. 9.Install the wall plate with the two short color-matched screws

provided.

10.Installation of the second W-84 control is identical. Repeat steps 1 through 7.

W-84

2 BLACK Wall Control

WIRES

2 RED WIRES

BLACK AND WHITE

STRIPED WIRE

(FIGURE #3)

25