Blade Installation Continued
Step 10b. Attach a blade/blade iron assembly to the flywheel by using two blade iron screws provided. Place the end of the blade iron on the flywheel as shown in Figure #5. Insert the screws one by one
using the provided screwdriver. Tighten securely by FLYWHEEL hand only. Repeat for each blade/blade iron assembly
until all five blades are attached to the fan as shown in Figure #6.
Caution: |
|
Blade screws must be tightened securely | Figure #5 |
before operating the fan. |
|
Figure #6
LIGHT FIXTURE Installation (optional)
NOTE: If you are installing your fan without a light kit attached as below in Figure #1, continue with these installation instruction Step 11a. If you have purchased a light kit for installation on your fan, skip this section and go to Step 13a on page 18 within this document.
Figure #1
14