Where to GET Warranty Service | Dolmar MS-251.4, MS-250.4 specification

F. WHERE TO GET WARRANTY SERVICE

It is recommended that warranty service be performed by the authorized dealer, who sold you the engine, although warranty service will be performed by any authorized dealers, distributors and warranty stations anywhere in the United States. When warranty repair is needed, the engine must be brought to an authorized dealer, distributorship or warranty station's place of business during normal business hours. In all cases, a reasonable time, not to exceed 30 days, must be allowed for the warranty repair to be completed after the engine is received by the authorized dealer, distributor or service station.

G. MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION-RELATED PARTS

Only warranted engine replacement parts approved by Makita U.S.A., Inc. should be used in the performance of any warranty maintenance or repairs on emission-related parts. If other than authorized parts are used for maintenance, replacement or repair of components affecting emission control, you should assure yourself that such parts are warranted by their manufacturer to be equivalent to authorized parts in performance and durability. Makita U.S.A., Inc., however, assumes no liability under this warranty with respect to parts other than authorized parts. The use of non-authorized replacement parts does not invalidate the warranty on other components unless the non-authorized parts cause damage to warranted parts.

H. PARTS COVERED UNDER THE CALIFORNIA EMISSION WARRANTY

1)Fuel Metering system

(i)Carburetor and internal parts

(ii)Air cleaner plate ( including choke system)

(iii)Air cleaner cover

(iv)Air cleaner element

(v)Fuel Filter

2)Ignition System

(i)Spark plug

(ii)Flywheel magneto

(iii)Ignition coil

3)Miscellaneous Item Used in Above Systems

(i)Hoses and sealing gaskets, bolts, connectors, and assemblies.

I. MAINTENANCE STATEMENTS

It is your responsibility to have all scheduled inspection and maintenance service performed at the times recommended in the 2000 and later Owner's Manual and to retain proof that inspection and maintenance service are performed at the times when recommended. Makita U.S.A., Inc. will not deny a warranty claim solely because you have no record of maintenance; however, Makita U.S.A., Inc. may deny a warranty claim if your failure to perform required maintenance resulted in the failure of warranted part. The proof, which you maintain, should be given to each subsequent owner of the engine. You are responsible for performing the scheduled maintenance described below based on the procedures specified in the 2000 and later Owner's Manual. The scheduled maintenance below is based on the normal engine-operating schedule.

PROCEDURE

1)Clean engine and check bolts and nuts. Retighten if necessary.

2)Check and refill engine oil (4stroke)

3)Change engine oil (4stroke)

4)Check clogging of cooling air passage and cylinder fins. Remove and clean if necessary.

5)Clean air cleaner.

6)Check spark plug. Clean and adjust if necessary.

7)Check muffler exhaust outlet (or port). Clean if necessary.

8)Check fuel filter. If clogged, replace with new one.

9)Adjust valve clearance, if applicable (4stroke).

10)Replace fuel lines.

11)Overhaul engine.

12)Replace packings and gaskets and gaskets with new ones.

INTERVAL

:Every 8 hours (daily)

:Every 8 hours (refill daily up to upper limit) :Initial 20 hours and every 50 hours afterward :Every 8 hours (daily)

:Every 8 hours (daily) :Every 8 hours (daily) :Every 50 hours (monthly) :Every 50 hours (monthly) :Every 200 hours (yearly) :Every 200 hours (yearly) :Every 200 hours (yearly) :Every reassembling