Husqvarna ProFlex 18 manual Dismantling the cutting unit, Take care. Risk of crushing injury

Page 39

MAINTENANCE

Dismantling the cutting unit

WARNING!

Take care. Risk of crushing injury

1.Place the Rider on a level surface.

2.Apply the brakes by pressing down the pedal and lock using the pushbutton.

3.Lift up the unit using the lifting lever.

4.Remove the nose.

5.Remove the belt adjuster’s spring.

6.Take the belt off the front pulley.

7.Hook on the belt adjuster’s spring again.

8. Hang the belt around the handle.

8009-001

8009-007

8009-008

8009-009

English – 37

Image 39

Contents English Rider ProFlexSvenska Contents Towing InstructionDear customer Travel and transport on public roadsSafety Instructions Good serviceSerial number Read the instructions Explanation of SymbolsGeneral use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Never run the machine in an enclosed area TransportPresentation PresentationLocation of the controls Speed of the machine is steplessly regulated Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitFuelling Lever for adjustment of the cutting heightParking brake SeatDriving Before startingStarting the engine Driving the machine 6007-210 MAX Cutting tipsDisengage lever Stopping the engineMaintenance Maintenance scheduleYear Year 100 300 Hours Before afterRight-hand fender Dismantling of the machine hoodsEngine hood NoseTransmission cover Check the engine’s cooling air intakeCheck the transmission’s air intake Left-hand fenderChecking and adjustment of the steering wires Checking and adjusting the choke wire Checking and adjustment of the throttle wireAdjusting the hydrostatic wire Adjusting the brakes Poorly adjusted brakes can result in reduced braking powerChecking the tyre pressure Replacing the air filter Replacement of the fuel filter Cleaning the pulse air filterChecking of the fuel pump’s air filter Check the level of the battery acid Procedures on contact with acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Take care. Risk of crushing injury Fitting the cutting unitBelt diagram Watch your fingers. Do not turn the blades or beltCheck that the belt is fitted around the tension roller Cutting height ParallelismReplacing the break-pin BioClip Checking the blades Service position for the cutting unitPlacing in the service position Releasing from the service positionDismantling the cutting unit 8009-169 Dismantling the belt Removing the attachment frameAssembling the belt Replacing the cutting unit’s belts Belt replacement on BioClipBelt replacement on BioClip112 Cutting unit models Removal of BioClip plug CombiLubrication Lubrication chartLubricating wires GeneralPedal mechanism in frame tunnel Engine oil Chains in frame tunnelTransmission Gear leverThrottle and choke wires, lever bearings Triangular linkDriver’s seat Transmission oil level Oil filter, replacementParking brake wire Belt tensionerProblem Procedure Trouble Shooting ScheduleService StorageWinter storage Wiring Diagram Rider ProFlex Technical DataRear ejector BioClip Rear ejector CombiEU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityWork done ServicejournalPre-delivery service After first 8 hoursHour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00