Husqvarna ProFlex 18 manual Belt diagram, Watch your fingers. Do not turn the blades or belt

Page 35

MAINTENANCE

4.Slide in the unit so that the inner pins (B) bottom in the attachment frame’s groove.

5.Hook the rear end of the height adjustment arm

(E) in place:

Set the cutting height lever to the forward position. Release the pressure from the arm if necessary by lifting or pushin down on the front of the frame.

WARNING!

Watch your fingers. Do not turn the blades or belt.

6.Disconnect the belt adjuster spring and fit the belt over the front pulley. The new belt will be shorter. If necessary, fit a spanner over the centre bolt and turn the front pulley.

7.Hook on the belt adjuster’s spring again.

IMPORTANT INFORMATION

Check that the belt is fitted around the tension roller.

Belt diagram

1.Drive belt

2.Front pulley

3.Tension roller

4.Belt adjuster spring

8.Refit the nose.

8009-018

E

8009-168

8009-008

3

4

1

2

6016-105

English – 33

Image 35

Contents English Rider ProFlexSvenska Contents Towing InstructionDear customer Travel and transport on public roadsSerial number Safety InstructionsGood service Read the instructions Explanation of SymbolsGeneral use Safety instructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Never run the machine in an enclosed area TransportLocation of the controls PresentationPresentation Speed of the machine is steplessly regulated Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitFuelling Lever for adjustment of the cutting heightParking brake SeatStarting the engine DrivingBefore starting Driving the machine 6007-210 MAX Cutting tipsDisengage lever Stopping the engineYear MaintenanceMaintenance schedule Year 100 300 Hours Before afterRight-hand fender Dismantling of the machine hoodsEngine hood NoseTransmission cover Check the engine’s cooling air intakeCheck the transmission’s air intake Left-hand fenderChecking and adjustment of the steering wires Checking and adjusting the choke wire Checking and adjustment of the throttle wireAdjusting the hydrostatic wire Checking the tyre pressure Adjusting the brakesPoorly adjusted brakes can result in reduced braking power Replacing the air filter Checking of the fuel pump’s air filter Replacement of the fuel filterCleaning the pulse air filter Fitting the wrong spark plug type can damage the engine Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Take care. Risk of crushing injury Fitting the cutting unitCheck that the belt is fitted around the tension roller Belt diagramWatch your fingers. Do not turn the blades or belt Cutting height ParallelismReplacing the break-pin BioClip Checking the blades Service position for the cutting unitPlacing in the service position Releasing from the service positionDismantling the cutting unit 8009-169 Dismantling the belt Removing the attachment frameAssembling the belt Replacing the cutting unit’s belts Belt replacement on BioClipBelt replacement on BioClip112 Cutting unit models Removal of BioClip plug CombiLubrication Lubrication chartPedal mechanism in frame tunnel Lubricating wiresGeneral Engine oil Chains in frame tunnelTransmission Gear leverDriver’s seat Throttle and choke wires, lever bearingsTriangular link Transmission oil level Oil filter, replacementParking brake wire Belt tensionerProblem Procedure Trouble Shooting ScheduleWinter storage ServiceStorage Wiring Diagram Rider ProFlex Technical DataRear ejector BioClip Rear ejector CombiEU declaration of conformity Only applies to Europe EU-DECLARATION of ConformityWork done ServicejournalPre-delivery service After first 8 hoursHour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00