Husqvarna P 525D, P 520D manual Rops Roll Over Protective Structure, Auxiliary lift system

Page 16

PRESENTATION

ROPS (Roll Over Protective Structure)

ROPS is a protective frame that reduces the risk of injury in the event of overturning. Use ROPS and a safety belt when driving on slopes.

The frame can be folded down. Remove the two pins that hold the frame and fold it backwards.

If the frame is folded down the safety belt should NOT be used.

If the frame is folded up, the safety belt must be used.

When the safety belt is not used, it must be wrapped around the chair back and tightened.

Auxiliary lift system

The auxiliary lift system transfers the weight of the cutting unit pivot wheel to the machine's front wheel.

The effect of the auxiliary lift system can be adjusted by moving the gas spring up or down.

Maximum effect is obtained when the gas spring is placed in the top hole.

No effect is obtained in the slot at the bottom.

When using the cutting unit, the gas spring must be mounted in the top hole.

16 – English

Image 16

Contents 520D 525D EnglishContents Pre-delivery service After the ﬁrst 25 hoursIntroduction Dear CustomerDriving and transport on public roads TowingGood service KEY to Symbols SymbolsWhat is WHAT? Location of the controlsSafety Instructions Safety instructionsInsure your Rider General useDriving on slopes This is what you doMaintenance ChildrenTransport Presentation Adjusting the cutting height Lever for hydraulic lift of attachmentsLifting the Cutting Unit Transport Position Lowering the Unit Mowing PositionLights and power outlet Safety instructionsSeat FuelingInstrument panel Bypass valvesRops Roll Over Protective Structure Auxiliary lift systemStarting and driving when cold Starting EngineBefore starting Start the engineConnecting the jump leads Starting the engine with a weak batteryRemove the cables in the reverse order Driving Driving the RiderBraking Stop the engineCutting tips Other objects which can be thrown out by the blades800 Maintenance scheduleStarting Completed Removing of the machine hoods CleaningChecking the engine’s cooling air intake Adjustment of pump and alternator belt Adjusting the parking brakeReplacement of fuel ﬁlter Change pump and alternator beltCleaning the air ﬁlter Cleaning the engine and mufﬂerCleaning the ﬁlter cover Replacing the air ﬁlterCheck the safety system Replacing the light bulbsMain fuse Checking the tyre pressureCutting Unit Components Check the batteryFitting the cutting head Pins are loosened. Observe caution to avoid Removing the cutting unitLift arms move with great force when Trapping your handService position for the cutting unit Placing in the service positionRestoring from service position Cutting height and tilt angle adjustmentCutting height Replacing the cutting unit belts Checking the bladesRemoving the BioClip plug Tilt angleAdjustment of PTO belts Change PTO beltsChange coolant Glycol Water Freezing pointLubrication schedule GeneralAccessories Pivot wheel bearingsCutting unit bevel gear Universal drive shaft jointsDrive shaft front support bearing Drive shaft rear support bearingSteering cylinder Joint bearingChanging the oil ﬁlter Check the hydraulic system oil levelReplacing the engine oil Drained directly after stopping the engineKnobs for setting the cutting height Lubricate the parking brake wireDriver seat Lubricating the cablesProblem Procedure Engine does not start Engine seems to have no powerStarter motor does not turn over the engine Engine does not run smoothlyEngine overheats Battery does not chargeUneven mowing Electrical System Wiring diagram P 520D Electrical System Electrical System Electrical System Electrical System Electrical System Wiring diagram P525 D Electrical System Electrical System Electrical System Electrical System Electrical System Winter storage ServiceGuard Technical Data Sound levels see note EC-declaration of conformity Applies to Europe onlyVibration levels see note 1154837-26 ´z+Vsh¶6¨ ´z+Vsh¶6¨ Original instructions