Husqvarna 265 ACX manual Installation

Page 31

3. INSTALLATION

3.Place the cable ends in the connector:

•Open the connector.

•Place the wire in the connector grip.

4.Press the connector together using a pair of pliers. Press until you hear a click.

5.Cut off any surplus boundary wire. Cut 1 - 2 cm above respective connectors.

6.Press the connector onto the contact pin,

marked A, on the charging station.

IMPORTANT INFORMATION

The right hand connector should be connected on the right hand contact pin on the charging station and vice versa.

English - 31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Husqvarna Automower 265 ACX OPERATOR’S Manual Page Table of Contents Table of Contents Introduction Introduction and safetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualImportant Information Xxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Automower, what’s what? Capacity Function of AutomowerMowing technique Working method Movement pattern Search method 1 Irregular Search method 2 Follow boundary wireSearch method 3 Follow guide wire Search methodOne Automower in several gardens More than one Automower in a gardenGPS communication unit Carry out the installation in the following steps InstallationPreparations Best charging station location Installation of the charging stationImportant Information Installation Do not tread or walk on the charging station plate Installation and connecting the charging stationAutomower cannot be used before the installation is complete Charging the batteryBest position for the boundary wire Installation of the boundary wireBoundaries for the working area Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º 90º Activate the GPS anti-theft Protection area Use Charging a discharged batteryUsing GPS-communication Using the timerSMS feature Remarks Commands Description CommandsGPS anti-theft protection Starting Automower Restart within 20 seconds Switching off AutomowerStopping Automower RestartAdjusting the cutting height Control panel Shortcuts Numbers Main switchNumber series Menu functionsMain menu Browse between menusAutomower Main menu Timer CommandsMon Tue Wed Thu Fri Sat Sun Run all Reset all timersYES Start time 1 Stop time 1 Start time 2 Stop time 2End angle 1 InstallationReversing distance Start angle 1When this function is activated Automower will To follow the boundary wire or a guide wire awayGardens where the front and back are joined by a Passage where the charging station cannot beFollow loop DirectionDistance ProportionCorridor width Test Test OUT Normal SettingsDrive past wire OpenTime lock4-1-2 PIN codeGPS Alarm4-1-3Date format Set timeSet date Time formatGarden example Proposed installation and settingsExit angles 250 Exit anglesCorridor width Guide 1 Exit angles 70 Battery MaintenanceCharging station ServiceWinter storage AutomowerChassis CleaningAfter winter storage Underframe and blade discTransport and moving Replacing the bladesBody Fault messages Trouble shootingTrouble Shooting Trouble Shooting Fault symptom Data Automower 265 ACX Technical dataData GPS communication unit Environmental Information Environmental informationEU Declaration of Conformity only applies to Europe EU declaration of conformityPage Page Original Instructions
Related manuals
Manual 2 pages 27.84 Kb
Top Page Image Contents