Husqvarna 265 ACX Installation, Preparations, Carry out the installation in the following steps

Page 17

3. INSTALLATION

3. Installation

This chapter describes how you install Husqvarna Automower®. Before starting the installation read the previous chapter 2. Presentation.

Read the whole of this chapter too before starting the installation. How the installation is made also affects how well Automower® will work. It is therefore important to plan the installation carefully.

Planning is simplified if you make a sketch of the working area, including all obstacles. This makes it easier to see the ideal positions for the charging station, boundary wire and guide wire, if used. Draw on the sketch how the boundary wire and the guide wire, if used, should be routed.

Carry out the installation in the following steps:

3.1Preparations.

3.2Installation of the charging station.

3.3Charging the battery.

3.4Installation of the boundary wire.

3.5Connecting the boundary wire.

3.6Checking the installation.

3.7Linking Automower® to the charging station.

3.8Installation of the guide wire.

To carry out a complete start-up of Automower® the charging station must be in position and connected, the boundary wire connected, and the mower connected to the charging station. If you would like to start the mower without having completed the full boundary installation, you can connect a temporary short loop around the mower.

3.1 Preparations

1.If the lawn in the proposed working area is taller than 10 cm, mow it using a normal lawn mower. Then collect the clippings.

2.Read carefully through all the steps before the installation.

3.Check that all parts for the installation are

included:

The numbers in brackets refer to the detail diagram 2.1 Automower®, what’s what? on page 11.

• Operator’s Manual (27)

• Automower®

•Charging station (16)

•Transformer (20)

•Low voltage cable (21)

English - 17

Image 17

Contents Husqvarna Automower 265 ACX OPERATOR’S Manual Page Table of Contents Table of Contents Introduction Introduction and safetySymbols on Automower Important Information Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualXxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Automower, what’s what? Mowing technique Function of AutomowerCapacity Working method Movement pattern Search method 3 Follow guide wire Search method 2 Follow boundary wireSearch method Search method 1 IrregularGPS communication unit More than one Automower in a gardenOne Automower in several gardens Preparations InstallationCarry out the installation in the following steps Best charging station location Installation of the charging stationImportant Information Installation Do not tread or walk on the charging station plate Installation and connecting the charging stationAutomower cannot be used before the installation is complete Charging the batteryBest position for the boundary wire Installation of the boundary wireBoundaries for the working area Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º 90º Activate the GPS anti-theft Protection area Use Charging a discharged batterySMS feature Using the timerUsing GPS-communication GPS anti-theft protection Description CommandsRemarks Commands Starting Automower Stopping Automower Switching off AutomowerRestart Restart within 20 secondsAdjusting the cutting height Control panel Shortcuts Numbers Main switchMain menu Menu functionsBrowse between menus Number seriesAutomower Main menu Timer CommandsYES Reset all timersStart time 1 Stop time 1 Start time 2 Stop time 2 Mon Tue Wed Thu Fri Sat Sun Run allReversing distance InstallationStart angle 1 End angle 1Gardens where the front and back are joined by a To follow the boundary wire or a guide wire awayPassage where the charging station cannot be When this function is activated Automower willDistance DirectionProportion Follow loopCorridor width Test Test OUT Drive past wire SettingsOpen NormalTime lock4-1-2 PIN codeGPS Alarm4-1-3Set date Set timeTime format Date formatGarden example Proposed installation and settingsExit angles 250 Exit anglesCorridor width Guide 1 Exit angles 70 Battery MaintenanceWinter storage ServiceAutomower Charging stationAfter winter storage CleaningUnderframe and blade disc ChassisBody Replacing the bladesTransport and moving Fault messages Trouble shootingTrouble Shooting Trouble Shooting Fault symptom Data GPS communication unit Technical dataData Automower 265 ACX Environmental Information Environmental informationEU Declaration of Conformity only applies to Europe EU declaration of conformityPage Page Original Instructions

Related manuals

Manual 2 pages 27.84 Kb