Husqvarna 265 ACX manual Trouble Shooting

9. TROUBLE SHOOTING

Fault message	Cause	Action
Outside working area	If this occurs in isolated areas it may	Try moving the boundary wire.
	be due to interference from metallic
	objects (perimeter fence,
	reinforcement bar) or buried cables in
	the vicinity.
	The working area slopes too much.	Check that the boundary wire has
		been routed correctly.
	The boundary wire has been routed	Check that the boundary wire has
	the wrong way around an island.	been routed in accordance with the
		installation instructions.
	The boundary wire is too close to the	Check that the boundary wire has
	edge of the working area.	been routed correctly.
Low battery voltage	Automower® cannot find the charging	Change the search settings
	station.	according to the Follow loop in (3-2-2)
		on page 53.
		Change the position of the charging
		station.
	The battery is spent.	Expected life is 1 - 4 years. Contact
		your dealer to replace the battery.
Wrong PIN code	Wrong PIN code has been entered.	Enter the correct PIN code.
	Three attempts are permitted, the
	keypad is then blocked for five
	minutes.
PIN code expired	The Time lock (4-1-2) function has	This is normal. Enter the correct PIN
	been activated because the selected	code.
	number of days has expired.
	Anti-theft protection in the GPS	Return the mower to the anti-theft
	module has been activated because	area and enter the correct PIN code.
	the mower is outside the anti-theft	If the message is displayed in the
	area.	intended working area, the anti-theft
		area radius needs to be increased.
No drive	Automower® has got caught in	Free the mower and rectify the
	something.	reason for the lack of drive. If it is due
		to wet grass, wait until the lawn has
		dried before using the mower.
	The working area includes a steep	Maximum guaranteed slope is 35%.
	slope.	Steeper slopes should be isolated.
	The guide wire is not laid at an angle	If the guide wire is laid on a slope, it
	on a slope.	must be laid at an angle across the
		slope.
No contact in charging	Automower® makes poor contact with	Check that Automower® has docked
station	the contact strips in the charging	correctly in the charging station.
	station.
Charging station	The contact between the charging	Place Automower® in the charging
blocked	strips and contact strips may be poor	station and check that the charging
	and Automower® has made a number	strips and contact strips make good
	of charging attempts.	contact.
	An object is obstructing Automower®.	Remove the object.

70 - English