Husqvarna 265 ACX manual Trouble Shooting

Page 71

9. TROUBLE SHOOTING

Fault message	Cause	Action


Stuck in charging	An object is preventing Automower®	Remove the object.
station	from reversing out of the charging
	station.

Upside down	Automower® leans too much or has	Turn the mower the right way up.
	turned over.

Needs manual	Automower® is set in MAN operating	This behaviour is normal; no action
charging	mode.	required.

Check ultrasonic	Debris, dust or similar has clogged	Clean the two ultrasonic sensors on
	the ultrasonic sensor.	the mower's body.

	Automower® has collided at too great	Place boundary wire around
	a speed a number of times.	obstacles not discovered by the
		ultrasonic.

English - 71

Image 71

Contents Husqvarna Automower 265 ACX OPERATOR’S Manual Page Table of Contents Table of Contents Introduction Introduction and safetySymbols on Automower Important Information Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualXxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Automower, what’s what? Mowing technique Function of AutomowerCapacity Working method Movement pattern Search method 1 Irregular Search method 2 Follow boundary wireSearch method 3 Follow guide wire Search methodGPS communication unit More than one Automower in a gardenOne Automower in several gardens Preparations InstallationCarry out the installation in the following steps Best charging station location Installation of the charging stationImportant Information Installation Do not tread or walk on the charging station plate Installation and connecting the charging stationAutomower cannot be used before the installation is complete Charging the batteryBest position for the boundary wire Installation of the boundary wireBoundaries for the working area Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º 90º Activate the GPS anti-theft Protection area Use Charging a discharged batterySMS feature Using the timerUsing GPS-communication GPS anti-theft protection Description CommandsRemarks Commands Starting Automower Restart within 20 seconds Switching off AutomowerStopping Automower RestartAdjusting the cutting height Control panel Shortcuts Numbers Main switchNumber series Menu functionsMain menu Browse between menusAutomower Main menu Timer CommandsMon Tue Wed Thu Fri Sat Sun Run all Reset all timersYES Start time 1 Stop time 1 Start time 2 Stop time 2End angle 1 InstallationReversing distance Start angle 1When this function is activated Automower will To follow the boundary wire or a guide wire awayGardens where the front and back are joined by a Passage where the charging station cannot beFollow loop DirectionDistance ProportionCorridor width Test Test OUT Normal SettingsDrive past wire OpenTime lock4-1-2 PIN codeGPS Alarm4-1-3Date format Set timeSet date Time formatGarden example Proposed installation and settingsExit angles 250 Exit anglesCorridor width Guide 1 Exit angles 70 Battery MaintenanceCharging station ServiceWinter storage AutomowerChassis CleaningAfter winter storage Underframe and blade discBody Replacing the bladesTransport and moving Fault messages Trouble shootingTrouble Shooting Trouble Shooting Fault symptom Data GPS communication unit Technical dataData Automower 265 ACX Environmental Information Environmental informationEU Declaration of Conformity only applies to Europe EU declaration of conformityPage Page Original Instructions

Related manuals

Manual 2 pages 27.84 Kb