3. INSTALLATION
•Screws for the charging station (24)
•Measurement gauge (25)
•Connector for the loop wire (23)
•Solderless coupler for the loop wire (26)
Contact your dealer to purchase the following installation material:
•Loop wire for the boundary wire and guide wire (19)
•Staples (22)
During installation you will also need:
•Hammer/plastic mallet to simplify putting the staples in the ground
•Combination pliers for cutting the boundary wire and pressing the contact units together.
• Edge cutter/straight spade if the boundary wire must be buried.
3.2Installation of the charging station
Best charging station location
Take the following aspects into consideration when identifying the best location for the charging station:
•Allow for 3 metres of free space in front of the charging station
•Close to a wall socket. The supplied low voltage cable is 20 metres long.
•A level surface to place the charging station on.
•Protection from water spray for instance from irrigation
•Protection from direct sunlight
•Place in the lower part of a working area that has a major slope
•Possible requirement to keep the charging station out of sight for outsiders
•Any aesthetic preferences
For examples of where best to install the charging station, see 7. Garden example on page 61.
If you are going to install a guide wire, read 3.8 Installation of the guide wire, see page 33, before choosing the position of the charging station.
18 - English