Husqvarna 265 ACX manual Installation

Page 20

3. INSTALLATION

The transformer shall be mounted on a vertical surface, for example a house wall. Mount the transformer with screws in the two attachment points. Securing screws are not included. Choose screws suitable for the wall material.

Mount the transformer at a height such that there is no risk the transformer can become submerged in water (minimum 30 cm from the ground). The transformer must never be placed on the ground.

Do not put the charging station in a corner or pocket in the working area.

Avoid placing the charging station in a narrow passage (narrower than about 3 metres).

Do not position the charging station so that the mower can come closer than 3 metres behind the charging station (for example on a narrow point). The mower will not then find the charging station.

min 30cm/12”

20 - English

Image 20

Contents Husqvarna Automower 265 ACX OPERATOR’S Manual Page Table of Contents Table of Contents Introduction and safety IntroductionSymbols on Automower Important Information Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualXxxxxx xxxxx xxxx xxxx xxxxx Safety instructions UseMaintenance TransportPresentation Automower, what’s what? Mowing technique Function of AutomowerCapacity Working method Movement pattern Search method 2 Follow boundary wire Search method 3 Follow guide wireSearch method Search method 1 IrregularGPS communication unit More than one Automower in a gardenOne Automower in several gardens Preparations InstallationCarry out the installation in the following steps Installation of the charging station Best charging station locationImportant Information Installation Installation and connecting the charging station Do not tread or walk on the charging station plateCharging the battery Automower cannot be used before the installation is completeInstallation of the boundary wire Best position for the boundary wireBoundaries for the working area Boundaries within the working area Secondary areasPassages when mowing Passages when searching for the charging stationSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wireConnecting the boundary wire Installation Checking the installation Linking Automower to the charging stationInstallation of the guide wire Need of a guide wirePlacement and connection of the guide wire Maximum 135º 90º Activate the GPS anti-theft Protection area Charging a discharged battery UseSMS feature Using the timerUsing GPS-communication GPS anti-theft protection Description CommandsRemarks Commands Starting Automower Switching off Automower Stopping AutomowerRestart Restart within 20 secondsAdjusting the cutting height Control panel Shortcuts Main switch NumbersMenu functions Main menuBrowse between menus Number seriesAutomower Main menu Commands TimerReset all timers YESStart time 1 Stop time 1 Start time 2 Stop time 2 Mon Tue Wed Thu Fri Sat Sun Run allInstallation Reversing distanceStart angle 1 End angle 1To follow the boundary wire or a guide wire away Gardens where the front and back are joined by aPassage where the charging station cannot be When this function is activated Automower willDirection DistanceProportion Follow loopCorridor width Test Test OUT Settings Drive past wireOpen NormalPIN code Time lock4-1-2Alarm4-1-3 GPSSet time Set dateTime format Date formatProposed installation and settings Garden exampleExit angles Exit angles 250Corridor width Guide 1 Exit angles 70 Maintenance BatteryService Winter storageAutomower Charging stationCleaning After winter storageUnderframe and blade disc ChassisBody Replacing the bladesTransport and moving Trouble shooting Fault messagesTrouble Shooting Trouble Shooting Fault symptom Data GPS communication unit Technical dataData Automower 265 ACX Environmental information Environmental InformationEU declaration of conformity EU Declaration of Conformity only applies to EuropePage Page Original Instructions

Related manuals

Manual 2 pages 27.84 Kb