3Com 7000 manual To configure the FastBUS

Options: 0 - Conventional

1 - Bank 1 (1*60MB/s)

2 - Bank 2 (1*60MB/s) The factory default is 0.

Your choices are displayed.

The following is an example of the FastBUS configuration.

For each of the 16 resident ELANs, enter a number in the range 0-2select the bank assignment for the ELAN from the list of three possibilities:

Integrated Fast Setup 63

LECS Address

--=---------

Active LECS addr:47.00.00.00.00.00.3c.00.00.a0.00.00.00.00.a0.3e.00.00.01.00

In PNNI mode, this section is not relevant and an appropriate message is displayed.

FastBUS Configuration Section This section prompts you to configure the FastBUS module. If no FastBUS module is installed, this section is skipped by the Integrated Fast Setup.

To configure the FastBUS:

1At the prompt, enter 1 to enable the FastBUS module or enter 0 to disable it.

2At the prompt, enter a number in the range 1-4to select the capacity of Bank 1 from the list of four possibilities:

	Options: 1-6*10MB/s
	2-3*20MB/s
	3-2*30MB/s
	4-1*60MB/s
	The factory default is 4.
	Your choice is displayed.
3	As in step 2, select the capacity of Bank 2.
4	to