3Com 7000 manual Loading a Single Configuration Data Type

Models: 7000

1 150
Download 150 pages 23.75 Kb
Page 78
Image 78
Loading a Single Configuration Data Type

78CHAPTER 6: CONFIGURING THE COREBUILDER 7000 FAMILY ATM SWITCH

7<LECS Topology>

8<LECS Order List>

9<Other>

Select File type:

Enter the number of the type of configuration parameters you want to upload. For example, if you want to upload all configuration parameters, select File type 1.

4Enter the IP address of the TFTP server:

Server IP address: 100.0.0.111

5Enter the name of the file to receive the data on disk:

Name of file to be uploaded: 7000_cfg

Enter a file name without an extension. For the “All” option, the system adds sequential extensions.

6Confirm the upload.

Start upload to 100.0.0.111, file name 7000_cfg, (Y/N)? y

The following messages are displayed for each data type:

Loading, file name switch/cfg/24_7_cfg.1, file type Box

Profile

Load process of file type Box Profile completed successfully

7Verify the success status of the upload by the LMA menu item:

(1)SYS:\ (3) LOA: \(1) STS

The upload status is displayed as follows:

Load process completed successfully.

The status will be “success” only if all the files were successfully loaded. In case of failure to load a file, the “load all” process will be stopped without continuing to the next file, a failure indication is displayed, and the display status option displays the error message:

General Error occurred while loading

Loading a Single Configuration Data Type

If you want to upload a single data type instead of the entire configuration, proceed as follows from step 3:

3Select File type: 2

4Server IP address: 100.0.0.111

5 Name of file to be uploaded: switch/cfg/box_prof.cfg

Page 78
Image 78
3Com 7000 manual Loading a Single Configuration Data Type