3 Installation
Before you start installing the “ServerView Integration in NetView” integration package, please make sure that you read all the installation requirements in this section.
If you want to install the integration package in a NetView client/server environment, proceed as follows:
1.ServerView Integration in NetView must be first installed on the NetView server.
2.If you need the functionality of the integration package on a NetView client, you can then install the package on that client.
3.1Hardware Requirements for All Systems
On your system, at least 2 MB of free disk space must be available in the global directory structure of NetView.
3.2Software Requirements for Windows NT
The software on the system must meet the following requirements:
–Windows 2000 (with Service Pack 1 or higher), Windows 2003 or Windows XP must be installed as the operating system.
–NetView V7.1 or higher must be installed in single, client or server mode.
–In NetView, two free contiguous event numbers in the range 1001 to 1999 must be available in the "NetView" enterprise.
INote that the installation of the ServerView V3.x software must occur before the installation NetView V7.1 if both management programs are to be run on the same system.
IThe installation and every call to the ServerView application activates the SNMP Trap Service on the system, which uses port 162. Since port 162 is also used by the NetView daemons, you should stop and disable the SNMP Trap Service manually (via the Services in the Control Panel) before starting the NetView daemon.
Integration in Tivoli NetView | 11 |
