3M-Matic 800rf Case Sealer Preventative Maintenance
Copyright 1999, 3M IPC. All rights reserved. 8-3
2. Side Belt Drive Assembly
At 250 hours, use multipurpose grease.
•Lightly coat chain pitches
(Figure 7-13, # 75).
3. Column Assembly
At 250 hours, use multipurpose grease.
•Lightly coat outside surface of the
column guides (Figure 7-6, #3).
4. Side Drive Belt/
Compression Roller Assembly Rails
At 250 hours, use 3M 5-Way Penetrant
(62-4696-2730-1).
•Lightly coat outside surface of bushing
(Figure 7-9, # 9).
At 250 hours, use multipurpose grease.
•Lightly coat rails (Figure 7-9, #4).
5. Infeed Roller Assemblies
At 250 hours, use multipurpose grease.
•Coat two (2) roller chains (Figure 7-24,
# 25) both sides, left front and right rear.
•Coat two (2) drive motor sprockets (Figure 7-
24, # 11) both sides, left front and right rear.
•Coat six (6) roller sprockets (Figure 7-24,
# 23) both sides, left front and right rear.
•Coat six (6) roller shafts (Figure 7-24,
# 19) both sides, left front and right rear.
6. Centering Rails Assembly
At 250 hours, use multipurpose grease.
•Lightly coat chain pitches
(Figure 7-25, #9 and #10).
Figure 8-3. Lubricating Main Assembly and Infeed Assembly