3M-Matic 800rf Case Sealer Installation
Copyright 1999, 3M IPC. All rights reserved. 2-27
19. Connect the air line from the Pneumatic Control
Panel to the air outlet on the regulator body.
a. Open the Pneumatic Control Panel (8 mm
hex wrench) and remove the center of the left
knockout grommet.
b. Locate the input air line, pull it out and loop
it around, then route it through the hole in
the left grommet (be careful not to kink the
air hose). Refer to Figure 2-30.
c. Connect the input air line to the air outlet by
inserting the air line fully into the collet and
pulling gently back to lock the air line into
place.
Figure 2-30. Rerouting Input Air Line