Adjustments 3M-Matic 800rf Case Sealer
3-12 Copyright 1999, 3M IPC. All rights reserved.
Figure 3-15. Flap Folder Arm Reed Switch Adjustment
Adjustment
1. Observe when the Flap Folder activates. It
should begin to move downward when the Flap
Folder Arm is about midway between fully
extended and fully retracted. Refer to Figure 3-
15.
2. Loosen the screw securing the switch bracket and
move the reed switch and bracket toward the rod
end of the cylinder to activate the Flap Folder
sooner. Move the switch and bracket toward the
cap end of the cylinder to activate the Flap Folder
later.
3. When the reed switch is set correctly, tighten the
screw securing the switch bracket. Avoid switch
movement while doing this.
3-14. Flap Folder Arm Reed Switch
This is not a routine adjustment. Normally, it is
necessary only after major disassembly or repair of
related components.
Specification
The factory set position of the circular bracket that
holds the reed switch to the Flap Folder Arm Cylinder
wall is approximately 2.5 inches from the cap end of
the cylinder. When the switch signals an output, the
Flap Folder Cylinder activates and the Flap Folder
moves downward, folding the rear flap of the box
inward.