3M 39800 - page 47

3M-Matic 800rf Case Sealer Installation

8. Remove the left and right mainframe brackets

that support the Pneumatic Control Panel. Refer

to Figure 2-24.

a. Remove 8 socket-head screws (6 mm)

securing the left support bracket to the case

sealer (4 screws holding the bracket to the

mainframe, and 4 screws holding the 2 L

brackets).

b. Remove 4 socket-head screws (6 mm)

securing the right support bracket to the case

sealer.

c. Save these screws and brackets for use later.

Moving Support Brackets and Installing Pneu-

matic Control Panel

9. Install the left support bracket and L brackets

(removed from the front of the machine) at the

rear of the machine. Refer to Figure 2-25. Secure

the brackets with the socket-head screws (6 mm).

10. Remove the right mainframe bracket from the

rear of the machine and install it at the front left

of the case sealer. Refer to Figure 2-25.

a. Remove the 6 socket-head screws (6 mm)

securing the mainframe bracket to the case

sealer (4 screws holding the bracket to the

mainframe, and 2 screws holding the bracket

to the underside of the door frame).

b. Install this bracket at the front left of the case

sealer. Secure the bracket to the mainframe

with 4 socket-head screws, and secure the

bracket to the underside of the door frame

with 2 socket-head screws.

11. Install the right support bracket (removed from

the front of the machine) at the rear right of the

case sealer. Refer to Figure 2-25. Secure the

bracket to the mainframe with 4 socket-head

screws.

12. Install the Pneumatic Control Panel at the rear of

the case sealer.

a. Lift the Pneumatic Control Panel from the

block and slide it through the undercarriage

to the rear of the case sealer.

b. Block the control panel and then lift it and

carefully set it onto the support brackets.

c. Hold the control panel in place and secure it

to the support brackets with 4 socket-head

screws.

Figure 2-24. Removing Support Brackets for

Pneumatic Control Panel