2-2 Copyright 1999, 3M IPC. All rights reserved.
2-2. Unpacking
ü Note
It is the responsibility of the customer to uncrate
the case sealer. Lifting equipment (forklift,
overhead crane, etc.) is necessary to lift the case
sealer from its pallet.
The case sealer is delivered in one crate.
Perform the following inspection upon receipt of the
case sealer.
1. Inspect the shipping crate for damage that could
indicate internal damage to the case sealer.
Report any damage, missing parts, or other
problems to:
3M Packaging Systems Division
Customer Support Center
Phone 1-800-328-1390
2. Dismantle the crate.
3. Inspect the case sealer and uninstalled compo-
nents for damage or missing parts. The crate
should also contain the following:
•One latching emergency stop switch with bracket
(electrically connected, but not mounted in place)
•One warning beacon with bracket (electrically
connected, but not mounted in place)
•One tool box containing:
1 wrench, tube, 17 mm
1 wrench, box/open, 13 mm & 10 mm
1 wrench, box/open, 8 mm & 7 mm
1 wrench, open end, 25 mm
1 wrench, hex key, 3 mm
1 wrench, hex key, 4 mm
1 wrench, hex key, 5 mm
1 wrench, hex key, 6 mm
1 spring, main upper (78-8070-1274-1)
1 spring, main lower (78-8070-1273-3)
4 springs, cutter (78-8052-6602-6)
2 blades, cutter (78-8017-9173-8)
1 tool, tape threading (78-8076-4726-4)
4. Report any damage, missing parts, or other
problems to:
3M Packaging Systems Division
Customer Support Center
Phone 1-800-328-1390
5. Move the case sealer to the point of use, but do
not place it into production until after the 3M
technician completes the checkout inspection.
Installation 3M-Matic 800rf Case Sealer