Table 3-1. Pneumatic Device Factory Set Points and Adjustment Locations (Continued)
Cylinder Mounted Speed Controls
Air Rate Exhaust Restriction
Controls (Speed Controls) Set Value Adjustment Location
Infeed Gate UP 3/4 of turn CCW On Gate Cylinder  Underside of entrance end of
case sealer
Infeed Gate DOWN Not applicable No control device is present
Fork UP 12 turns CCW On Fork Cylinder cap end  Remove center
conveyor bed to expose cylinder
Fork DOWN 13 turns CCW On Fork Cylinder rod end  Remove center
conveyor bed to expose cylinder
Folder Arm EXTEND 11 turns CCW On Folder Arm Cylinder rod end  Through access
holes in Arm Assembly cover
Folder Arm RETRACT 5 turns CCW On Folder Arm Cylinder cap end  Through access
holes in Arm Assembly cover
Rear Flap Folder EXTEND 16 turns CCW On Rear Flap Folder Cylinder rod end  Through
access holes in Folder Assembly cover
Rear Flap Folder RETRACT 10 turns CCW On Rear Flap Folder Cylinder cap end  Through
access holes in Folder Assembly cover
All adjustments are made from the fully closed position. Use a standard straight edge screwdriver or loosen the
knurled ring nut and adjust the thumbscrew fully CW, then turn the thumbscrew CCW the number of turns
specified above.
3M-Matic 800rf Case Sealer Adjustments
Copyright 1999, 3M IPC. All rights reserved. 3-3