2-30 Copyright 1999, 3M IPC. All rights reserved.
26. Connect the electrical connectors and cables to
the Electrical Control Panel.
a. Route the electrical connectors and cables
through the undercarriage to the rear of the
case sealer.
b. Connect the large electrical connector and
the two smaller infeed motor electrical
connectors to the receptacles located under
the Electrical Control Panel.
c. Connect the plastic conduit from the Pneu-
matic Control Panel to the receptacle located
under the Electrical Control Panel.
27. Install the E-Stop switch.
a. Locate the E-Stop switch and gently pull
sufficient wire (extra wire is coiled in the
frame) from the frame to route the E-Stop
switch under the machine to the front right
mainframe bracket.
b. Secure the E-Stop switch bracket to the
mainframe bracket with 1 socket-head screw.
Refer to Figure 2-34.
Figure 2-34. Installing E-Stop Switch and Bracket
Verify Correct Operation
28. Close all four sliding doors to engage the
interlock switches.
29. Connect the main air supply to the Air On/Off
Valve.
30. Connect the power cord to the electrical supply.
31. Turn on the case sealer air supply and electrical
power.
32. Verify correct operation by running test cartons
through the case sealer.
Installation 3M-Matic 800rf Case Sealer