3M 39800 - page 53

3M-Matic 800rf Case Sealer Installation

23. Remove the mainframe bracket and E-Stop

switch from the rear left of the machine and

install the mainframe bracket at the front right of

the case sealer. Refer to Figure 2-33.

a. Remove 1 socket-head screw securing the

E-Stop switch and bracket to the mainframe

bracket. Set the E-Stop switch aside; it will

be installed later.

b. Remove 6 socket-head screws (6 mm)

securing the mainframe bracket to the case

sealer (4 screws holding the bracket to the

mainframe, and 2 screws holding the bracket

to the two L brackets attached to the under-

side of the door frame).

c. Install this bracket at the front right of the

case sealer. Secure the bracket to the main-

frame and L brackets with 6 socket-head

screws.

Figure 2-33. Moving Support Brackets for Electrical Control Panel

24. Remove the left support bracket from the front

of the machine and install it at the rear left of the

case sealer. Refer to Figure 2-33.

a. Remove 4 socket-head screws (6 mm)

securing the left support bracket to the case

sealer.

b. Install this bracket at the rear left of the case

sealer. Secure the bracket to the mainframe

and L brackets with 6 socket-head screws.

25. Install the Electrical Control Panel at the rear of

the case sealer. This step requires two people.

a. With one person on each side, lift the

Electrical Control Panel from the blocks and

carefully set it onto the support brackets.

b. Hold the control panel in place and secure it

to the support brackets with 4 socket-head

screws.