8e6 Technologies ERH-100 (5K02-61) A Quick Start Setup Procedures, Link the Workstation to the ER

Step 1A: Quick Start Setup Procedures

Storage Device Setup (for Attached Storage Units)

If you have a NAS (SCSI Connected Storage Device or “SAN”) that will be used with the ER, you will need to connect it to the ER at this point. Refer to the Appendix at the end of this document for instructions on how to connect the SCSI Connected Storage Device.

Link the Workstation to the ER

Monitor and Keyboard Setup

A.Connect the PC monitor and keyboard cables to the rear of the chassis.

B.Turn on the PC monitor.

C.Power on the ER by dropping down the face plate and pressing the large button at the right of the front panel (see image below).

Front of the 1U chassis

Once the ER is powered up, proceed to the Login screen instructions.

Serial Console Setup

A.Using the serial port cable (and USB DB9 serial adapter, if necessary), connect the laptop to the rear of the chassis (see image below).

Rear of the 1U chassis

B.Power on the laptop.

C.Power on the ER by dropping down the face plate and pressing the large button at the right of the front panel (see first image above).

Once the ER is powered up, proceed to the instructions for HyperTerminal Setup Proce- dures.

22 8e6 Enterprise Reporter Quick Start Guide