Manuals / Brands / Computer Equipment / Scanner / ABL electronic / Computer Equipment / Scanner

ABL electronic Scamax 2600, Scamax 5000 5.3Parameter Configuration, 5.2.6Mode

1 42

Download 42 pages, 6.11 Mb

DpuScan

Scamax 2600 / 5000

Scanner Options

5.2.6Mode

The Mode is the summary of all settings and rules that will be described in the succeeding paragraphs. Depending on the scanner, up to 16 modes can be loaded permanently into the driver.

During a scan job, one mode is selected, as seen in Illustration 5 – Scanner Properties with Links to the Patchcode Controlled Index on page 15 .

All succeeding settings work only for this selected mode, as shown in the title bar of the setup dialogs in Illustration 7 – Patchcodes on page 23.

After these definitions, we refer to the configuration dialog, which appears when the corresponding button is pressed in the scanner’s setup dialog.

5.3Parameter Configuration

The parameter dialog shows four tabs to set the Patchcode search options, the counter options, and the endorser output. Below the pages there is a preview area to give the user an idea of the endorser’s printout.

Placed on the right side of the dialog are buttons to save and reload the setting for this mode, and a button labeled "Rules" that opens the "Control Configuration" dialog described later in this text (see Chapter 5.5 on page 38).

Page 22 of 42

Contents

Special Scanner Options for Scamax 2600 and Copyrights Trademarks Disclaimer Actuality Table of Contents Table of Illustrations 1 Description of the Scanner Options 1.1Introduction 2 Device Properties After Start of Document (5cm) Reduced No Length Control Fillcolor on overlength Manually Fillcolor on Underlength Fillcolor on Deskew Roller Cleaning White Calibration calibration 3 Image Processing Options DTplus Threshold (two-dimensional) Contrast Brightness DTplus Filter Tracker for Brightness Tracker for Contrast 4 Image Index Mode Patchcode Controlled Index Configuration Confirm Counters Patchcode-Controlled Index The Index Flags Document Level Sequential ID 5 Expanded Endorser Control for Scamax 5.1What it is and How it Works 5.2Terms and Definitions 5.2.1Header Page Length Level PageLength FlagM FlagL 5.2.2Image Address 5.2.3Counters Chapter Counter B Volume Counter C The leftmost part of the address is the Fixed Field Roll Number D 5.2.4Flags 5.2.5Level 5.2.6Mode 5.3Parameter Configuration Cancel Apply Help Rules… Save… 5.3.1Patchcodes 5.3.2How to Set and to Trigger Counters Reset Value Trigger Value (to cause 5.3.3How to Print Counters Counter Delimiter 5.3.4Level and Mode Output – "Print Flags" Tab 5.3.5Preview of Endorser and Header To enable a printout, the endorser must first be enabled: String 5.3.6Save and Load Modes 5.4Events and Actions 5.4.1Events 5.4.2Actions 5.4.3Course of Events and Actions field width reset incremented Counter A level stops endorser off 5.5Defining the Rule 5.5.1Counter Handling 5.5.2Setting Flags And Level Set Level for the next document Set Mode (Output only) 5.5.3Device Control