Manuals / Brands / Computer Equipment / Scanner / ABL electronic / Computer Equipment / Scanner

ABL electronic Scamax 2600, Scamax 5000 5.5.3Device Control, Endorser on, Endorser off, Stop Scanning, Discard the Sheet (front and rear side)

1 42

Download 42 pages, 6.11 Mb

Scanner Options

Scamax 2600 / 5000

DpuScan

5.5.3Device Control

Stop Scanning

Discard the Sheet (front and rear side)

Do not increment the automatic counters

Endorser on /

Endorser off

Illustration 16 – Device Control

This stops the scanner before the next sheet. The current sheet will be sent to the application unless it is not dropped.

If enabled, the document (front and rear side) will not be sent to the host.

This suppresses the automatic counting in Step 5 of the procedure as seen in the previous chapter.

This enables or disables the endorser from the next sheet on, and the current sheet is not affected.

If different rules enable and disable the endorser, the latter rule takes precedent.

Page 41 of 42

Contents

Special Scanner Options for Scamax 2600 and Copyrights Trademarks Disclaimer Actuality Table of Contents Table of Illustrations 1 Description of the Scanner Options 1.1Introduction 2 Device Properties After Start of Document (5cm) Reduced No Length Control Fillcolor on overlength Manually Fillcolor on Underlength Fillcolor on Deskew Roller Cleaning White Calibration calibration 3 Image Processing Options DTplus Threshold (two-dimensional) Contrast Brightness DTplus Filter Tracker for Brightness Tracker for Contrast 4 Image Index Mode Patchcode Controlled Index Configuration Confirm Counters Patchcode-Controlled Index The Index Flags Document Level Sequential ID 5 Expanded Endorser Control for Scamax 5.1What it is and How it Works 5.2Terms and Definitions 5.2.1Header Page Length Level PageLength FlagM FlagL 5.2.2Image Address 5.2.3Counters Chapter Counter B Volume Counter C The leftmost part of the address is the Fixed Field Roll Number D 5.2.4Flags 5.2.5Level 5.2.6Mode 5.3Parameter Configuration Cancel Apply Help Rules… Save… 5.3.1Patchcodes 5.3.2How to Set and to Trigger Counters Reset Value Trigger Value (to cause 5.3.3How to Print Counters Counter Delimiter 5.3.4Level and Mode Output – "Print Flags" Tab 5.3.5Preview of Endorser and Header To enable a printout, the endorser must first be enabled: String 5.3.6Save and Load Modes 5.4Events and Actions 5.4.1Events 5.4.2Actions 5.4.3Course of Events and Actions field width reset incremented Counter A level stops endorser off 5.5Defining the Rule 5.5.1Counter Handling 5.5.2Setting Flags And Level Set Level for the next document Set Mode (Output only) 5.5.3Device Control