Manuals / Brands / Computer Equipment / Scanner / ABL electronic / Computer Equipment / Scanner

ABL electronic Scamax 2600, Scamax 5000 1 Description of the Scanner Options, 1.1Introduction, jukscsi

1 42

Download 42 pages, 6.11 Mb

Scanner Options

Scamax 2600 / 5000

DpuScan

1 Description of the Scanner Options

1.1Introduction

This documentation is valid for the following scanners of the company InoTec:

•Scamax 2600 / Scamax 2500

•Scamax 5000

You must use the following driver: jukscsi

The scanner is connected using a standard SCSI interface board, and an ASPI driver must be installed.

This program module was developed to enable the user to set the special options of the Admis S31 scanner. The jukscsi driver from Janich & Klass forwards these settings to the scanner.

The special scanner settings are offered with the user interface, spread over several pages.

Page 5 of 42

Contents

Special Scanner Options for Scamax 2600 and Copyrights Trademarks Disclaimer Actuality Table of Contents Table of Illustrations 1 Description of the Scanner Options 1.1Introduction 2 Device Properties After Start of Document (5cm) Reduced No Length Control Fillcolor on overlength Manually Fillcolor on Underlength Fillcolor on Deskew Roller Cleaning White Calibration calibration 3 Image Processing Options DTplus Threshold (two-dimensional) Contrast Brightness DTplus Filter Tracker for Brightness Tracker for Contrast 4 Image Index Mode Patchcode Controlled Index Configuration Confirm Counters Patchcode-Controlled Index The Index Flags Document Level Sequential ID 5 Expanded Endorser Control for Scamax 5.1What it is and How it Works 5.2Terms and Definitions 5.2.1Header Page Length Level PageLength FlagM FlagL 5.2.2Image Address 5.2.3Counters Chapter Counter B Volume Counter C The leftmost part of the address is the Fixed Field Roll Number D 5.2.4Flags 5.2.5Level 5.2.6Mode 5.3Parameter Configuration Cancel Apply Help Rules… Save… 5.3.1Patchcodes 5.3.2How to Set and to Trigger Counters Reset Value Trigger Value (to cause 5.3.3How to Print Counters Counter Delimiter 5.3.4Level and Mode Output – "Print Flags" Tab 5.3.5Preview of Endorser and Header To enable a printout, the endorser must first be enabled: String 5.3.6Save and Load Modes 5.4Events and Actions 5.4.1Events 5.4.2Actions 5.4.3Course of Events and Actions field width reset incremented Counter A level stops endorser off 5.5Defining the Rule 5.5.1Counter Handling 5.5.2Setting Flags And Level Set Level for the next document Set Mode (Output only) 5.5.3Device Control