Scanner Options

Scamax 2600 / 5000

DpuScan

5.4.2Actions

There are three groups of Actions:

Actions that set counters

These can reset and then increment the counters. This may influence the counter-based events or the increment of the automatic counter.

Actions that set flags and level

These can change the flags, the mode, or the level. Changing the level disables checking for level-based events for the actual sheet, where changing the mode or the flags does not affect the further process.

Actions on the device control

These can drop the sheet, stop the scanner, or turn the endorser on and off.

5.4.3Course of Events and Actions

Rules define what actions shall be taken when a special event appears. Checking for the events and the execution of the resulting actions follows this procedure:

Step 0

Step 1

Patchcode-based events

Assume that the scanner has scanned a sheet and has done the Patchcode search. Both images (front and rear) and their headers are ready and waiting to be sent to the application.

Note: The headers for the current images will not be changed. All calculations and settings affect only the next sheet.

First of all the software checks if there was a Patchcode on the just incoming sheet.

If Patchcode search is disabled this step will be skipped.

If there was a code found on the sheet the search for further Patchcodes stops. So only one Patchcode is found on a sheet in a time.

If no Patchcode was found, the checking of the level (step 3) follows.

When a Patchcode-based rule becomes true the resulting actions take effect:

Page 35 of 42