Manuals / Brands / Computer Equipment / Scanner / ABL electronic / Computer Equipment / Scanner

ABL electronic Scamax 2600, Scamax 5000 3 Image Processing Options, Fixed Threshold, Binarization Method, Automatic Threshold (one-dimensional)

1 42

Download 42 pages, 6.11 Mb

Scanner Options

Scamax 2600 / 5000

DpuScan

3 Image Processing Options

To optimize image quality you can set different image processing parameters. They are offered on the next two pages, separately for Front and Back camera.

Illustration 2 – Inotec Options: Front Page

Binarization Method

The binarization method defines how the 256 possible grayscale values that come from the camera will be transformed into bitonal information (black and/or white pixels).

Fixed Threshold

One of the 256 grayscale values is defined as the fixed threshold for the brightness. All levels above will be represented as ”white”, and all others will be represented as ”black”. This simple method is suited for "normal" documents without special colors, stains, or bad print.

Recommended Value: Brightness = 165

Automatic Threshold (one-dimensional)

The changes in gray levels in one line of the image are used to decide what is black and what is white.

When deciding black or white, the scanner considers the previously read values of an image line. Depending on the contrast settings, deviation levels in the grayscale values are considered for the black/white decision dynamically.

Recommended Value: Brightness = 165; Contrast = 4

Page 9 of 42

Contents

Special Scanner Options for Scamax 2600 and Copyrights Trademarks Disclaimer Actuality Table of Contents Table of Illustrations 1 Description of the Scanner Options 1.1Introduction 2 Device Properties After Start of Document (5cm) Reduced No Length Control Fillcolor on overlength Manually Fillcolor on Underlength Fillcolor on Deskew Roller Cleaning White Calibration calibration 3 Image Processing Options DTplus Threshold (two-dimensional) Contrast Brightness DTplus Filter Tracker for Brightness Tracker for Contrast 4 Image Index Mode Patchcode Controlled Index Configuration Confirm Counters Patchcode-Controlled Index The Index Flags Document Level Sequential ID 5 Expanded Endorser Control for Scamax 5.1What it is and How it Works 5.2Terms and Definitions 5.2.1Header Page Length Level PageLength FlagM FlagL 5.2.2Image Address 5.2.3Counters Chapter Counter B Volume Counter C The leftmost part of the address is the Fixed Field Roll Number D 5.2.4Flags 5.2.5Level 5.2.6Mode 5.3Parameter Configuration Cancel Apply Help Rules… Save… 5.3.1Patchcodes 5.3.2How to Set and to Trigger Counters Reset Value Trigger Value (to cause 5.3.3How to Print Counters Counter Delimiter 5.3.4Level and Mode Output – "Print Flags" Tab 5.3.5Preview of Endorser and Header To enable a printout, the endorser must first be enabled: String 5.3.6Save and Load Modes 5.4Events and Actions 5.4.1Events 5.4.2Actions 5.4.3Course of Events and Actions field width reset incremented Counter A level stops endorser off 5.5Defining the Rule 5.5.1Counter Handling 5.5.2Setting Flags And Level Set Level for the next document Set Mode (Output only) 5.5.3Device Control