Manuals / Brands / Computer Equipment / Scanner / ABL electronic / Computer Equipment / Scanner

ABL electronic Scamax 2600, Scamax 5000 2 Device Properties, Active, Inactive, Double Feed Detection, Only Start of Document (5cm)

1 42

Download 42 pages, 6.11 Mb

DpuScan

Scamax 2600 / 5000

Scanner Options

2 Device Properties

The first page gives setting possibilities for double feed detection, length control, manual feeding mode, and fill color options.

Illustration 1 – Inotec Properties Tab: Device

Double Feed Detection

Standard Scamax Series document scanners are equipped with an ultrasonic double feed sensor. The sensor is active during the entire scanning process (over the complete length of the document) and gives an error report in the case of a double feed.

The following modes are available for double feed detection:

Active

Double feed detection is enabled.

Inactive

Double feed detection is disabled.

Only Start of Document (5cm)

The ultrasound sensor is active only for the first two inches of each original. Labels, Post-ItNotes, or other stickers that are not placed on top of the sheet, but at least two inches lower the top, will not cause a double feed error message to appear.

Page 6 of 42

Contents

Special Scanner Options for Scamax 2600 and Copyrights Trademarks Disclaimer Actuality Table of Contents Table of Illustrations 1 Description of the Scanner Options 1.1Introduction 2 Device Properties After Start of Document (5cm) Reduced No Length Control Fillcolor on overlength Manually Fillcolor on Underlength Fillcolor on Deskew Roller Cleaning White Calibration calibration 3 Image Processing Options DTplus Threshold (two-dimensional) Contrast Brightness DTplus Filter Tracker for Brightness Tracker for Contrast 4 Image Index Mode Patchcode Controlled Index Configuration Confirm Counters Patchcode-Controlled Index The Index Flags Document Level Sequential ID 5 Expanded Endorser Control for Scamax 5.1What it is and How it Works 5.2Terms and Definitions 5.2.1Header Page Length Level PageLength FlagM FlagL 5.2.2Image Address 5.2.3Counters Chapter Counter B Volume Counter C The leftmost part of the address is the Fixed Field Roll Number D 5.2.4Flags 5.2.5Level 5.2.6Mode 5.3Parameter Configuration Cancel Apply Help Rules… Save… 5.3.1Patchcodes 5.3.2How to Set and to Trigger Counters Reset Value Trigger Value (to cause 5.3.3How to Print Counters Counter Delimiter 5.3.4Level and Mode Output – "Print Flags" Tab 5.3.5Preview of Endorser and Header To enable a printout, the endorser must first be enabled: String 5.3.6Save and Load Modes 5.4Events and Actions 5.4.1Events 5.4.2Actions 5.4.3Course of Events and Actions field width reset incremented Counter A level stops endorser off 5.5Defining the Rule 5.5.1Counter Handling 5.5.2Setting Flags And Level Set Level for the next document Set Mode (Output only) 5.5.3Device Control