Manuals / Brands / Computer Equipment / Scanner / ABL electronic / Computer Equipment / Scanner

ABL electronic Scamax 2600, Scamax 5000 5.5.2Setting Flags And Level, Flag, Set momentary Flag, Set / Reset latched

1 42

Download 42 pages, 6.11 Mb

Scanner Options

Scamax 2600 / 5000

DpuScan

5.5.2Setting Flags And Level

Illustration 15 – Setting Flags and Level

Set momentary Flag Check this box to set the momentary flag in the header at Byte 155. The Patchcode Controlled Index does not verify this flag, but the scan application can use it to do something exactly for this one sheet, such as call a function or start a new chapter.

The momentary flag will be reset automatically for the next sheet.

Set / Reset latched This sets the permanent flag in the header at Byte 157. Once the latched

Flagflag is set, it remains set until it is reset by another rule or at the beginning of a new scan job.

Just as with the momentary flag, the Patchcode Controlled Index does not evaluate the permanent flag, but the scan application can use it to, for example, mark the addendum pages of a tax form.

Because the flag setting is not evaluated, it can be done immediately after verifying a rule. That means that the latched flag can be set by a rule and can be reset later by another rule on the same sheet.

Page 39 of 42

Contents

Special Scanner Options for Scamax 2600 and Copyrights Trademarks Disclaimer Actuality Table of Contents Table of Illustrations 1 Description of the Scanner Options 1.1Introduction 2 Device Properties After Start of Document (5cm) Reduced No Length Control Fillcolor on overlength Manually Fillcolor on Underlength Fillcolor on Deskew Roller Cleaning White Calibration calibration 3 Image Processing Options DTplus Threshold (two-dimensional) Contrast Brightness DTplus Filter Tracker for Brightness Tracker for Contrast 4 Image Index Mode Patchcode Controlled Index Configuration Confirm Counters Patchcode-Controlled Index The Index Flags Document Level Sequential ID 5 Expanded Endorser Control for Scamax 5.1What it is and How it Works 5.2Terms and Definitions 5.2.1Header Page Length Level PageLength FlagM FlagL 5.2.2Image Address 5.2.3Counters Chapter Counter B Volume Counter C The leftmost part of the address is the Fixed Field Roll Number D 5.2.4Flags 5.2.5Level 5.2.6Mode 5.3Parameter Configuration Cancel Apply Help Rules… Save… 5.3.1Patchcodes 5.3.2How to Set and to Trigger Counters Reset Value Trigger Value (to cause 5.3.3How to Print Counters Counter Delimiter 5.3.4Level and Mode Output – "Print Flags" Tab 5.3.5Preview of Endorser and Header To enable a printout, the endorser must first be enabled: String 5.3.6Save and Load Modes 5.4Events and Actions 5.4.1Events 5.4.2Actions 5.4.3Course of Events and Actions field width reset incremented Counter A level stops endorser off 5.5Defining the Rule 5.5.1Counter Handling 5.5.2Setting Flags And Level Set Level for the next document Set Mode (Output only) 5.5.3Device Control