Manuals / Brands / Computer Equipment / Scanner / ABL electronic / Computer Equipment / Scanner

ABL electronic Scamax 2600, Scamax 5000 5.4.1Events, Level, several, only one, Counter Events, Patchcode Events, one event at max

1 42

Download 42 pages, 6.11 Mb

DpuScan

Scamax 2600 / 5000

Scanner Options

Illustration 14 – Reset Values?

5.4.1Events

There are several groups of events:

Patchcode Events

These events happen when a certain Patchcode is recognized. Because the search is stopped after the first Patchcode found, only one such event can happen on any one page.

Level Events:

These events happen when a certain Level is set. Because only one Level can be valid, there will be one event at max. Therefore, you can decide whether a page in a contract belongs either to the contract itself, or to its addenda, for example.

Counter Events

Such an event happens when one of the counters reaches its trigger value. Because several counters may reach their trigger value on the same page, several such events can happen at one time as well.

Page 34 of 42

Contents

Special Scanner Options for Scamax 2600 and Copyrights Trademarks Disclaimer Actuality Table of Contents Table of Illustrations 1 Description of the Scanner Options 1.1Introduction 2 Device Properties After Start of Document (5cm) Reduced No Length Control Fillcolor on overlength Manually Fillcolor on Underlength Fillcolor on Deskew Roller Cleaning White Calibration calibration 3 Image Processing Options DTplus Threshold (two-dimensional) Contrast Brightness DTplus Filter Tracker for Brightness Tracker for Contrast 4 Image Index Mode Patchcode Controlled Index Configuration Confirm Counters Patchcode-Controlled Index The Index Flags Document Level Sequential ID 5 Expanded Endorser Control for Scamax 5.1What it is and How it Works 5.2Terms and Definitions 5.2.1Header Page Length Level PageLength FlagM FlagL 5.2.2Image Address 5.2.3Counters Chapter Counter B Volume Counter C The leftmost part of the address is the Fixed Field Roll Number D 5.2.4Flags 5.2.5Level 5.2.6Mode 5.3Parameter Configuration Cancel Apply Help Rules… Save… 5.3.1Patchcodes 5.3.2How to Set and to Trigger Counters Reset Value Trigger Value (to cause 5.3.3How to Print Counters Counter Delimiter 5.3.4Level and Mode Output – "Print Flags" Tab 5.3.5Preview of Endorser and Header To enable a printout, the endorser must first be enabled: String 5.3.6Save and Load Modes 5.4Events and Actions 5.4.1Events 5.4.2Actions 5.4.3Course of Events and Actions field width reset incremented Counter A level stops endorser off 5.5Defining the Rule 5.5.1Counter Handling 5.5.2Setting Flags And Level Set Level for the next document Set Mode (Output only) 5.5.3Device Control