120
3.5.3 Port mirroring configuration Click Port configuration, Port mirroring configuration. Users can configure port
mirroring.
3.5.3.1 Mirror configuration
Click Port configuration, Port mirroring configuration, Mirror configuration. Users can
configure port mirroring for source interface and destination interface.
Source Interface configuration. See the equivalent CLI command at 3.2.3.3.1:
& session – Mirroring session
& source interface list – Source interface list for mirroring
& Mirror direction – rx means that received traffic is mirrored; tx
means sent traffic is mirrored; both means both received and sent
traffic is mirrored.
For example: Select session 1; set source interface to eth1/1-4, set Mirror direction to
rx, and then click Apply. The configuration is applied on the switch.
Destination Interface configuration. See the equivalent CLI command at 3.2.3.3.2:
& session – Mirroring session
& destination interface – destination interface for mirroring
& tag – Set the vlan tag of the packets sent by the destination
interface. All means that all the packets have vlan tag; preserve
mean that if the packets with vlan tag when they enter the switch,
they keep vlan tag when they are sent out. If the packets without
vlan tag when they enter the switch, they don’t have vlan tag when
they are sent out.
For example: Select session 1; set source interface to 1/5; set tag to preserve, and
then click Apply. The configuration is applied on the switch.
Click Port configuration, Port debug and maintenance. It is used to enable port debug
management list for obtaining port information.