433
All interface and link protocols are in the UP state (use “show interface status”
command).
Then IP addresses of different network segment should be configured in all
interfaces.
Enable OSPF(use “router rip” command) first, then configure OSPF areas for
appropriate interfaces to reside in.
Next, note the nature of OSPF – OSPF backbone area (area 0) must be continuous,
if not, use virtual link to make it continuous; all non-0 areas must connect to the
others via area 0, direct connection between non-0 areas is not allowed; edge layer3
switch refers to the layer3 switch that partly belong to area 0 and partly belong to
non-0 area; for multi-access network like broadcast network, designated layer3
switch (DR) should be elected.
15.5 Web Management Click Route configuration. Users can configure routing protocols:
Static route configuration - Static route configuration
RIP configuration - RIP configuration
OSPF configuration - OSPF configuration
Show ip route - Show ip route
15.5.1 Static route Click Static route configuration.
15.5.1.1 Static route configuration
Click Static route configuration. The configuration page is shown. See the equivalent CLI
command at 15.2.3.2
The explanation of each field is as below:
Destination IP address - Destination IP address
Destination network mask - Destination network mask
Gateway ip – Next hop IP address
Priority – Route priority
Operation type – Add; Remove
For example: Add a route; set Destination IP address to 1.1.1.0; set Destination network
mask to 255.255.255.0; set Gateway ip to 2.1.1.1; Select, and then click Apply.