377
Related command: no ip rip send version
15.3.2.2.8 ip rip send version none
Command: ip rip send version none
Function: Disable sending RIP packets on the interface
Default: Sending RIP packet is enabled by default.
Command mode: Interface Mode
Usage Guide: This command is used with the other two commands “ip rip output” and
ip rip work”, “ip rip work” is equal to “ip rip input” & “ip rip output” in function, the latter
two commands control the receiving and sending of RIP packet on the interface, the
former equals the total of the latter two commands.
Related command: no ip rip send version
15.3.2.2.9 ip rip receive version
Command: ip rip receive version {1 | 2 | 1 2}
no ip rip receive version
Function: Configure RIP version to receive on the interface. The default setting is to
receive both RIP v1 and v2 packets; the “no ip rip receive version” command restores
the default setting, enables receiving RIP packets on the interface.
Parameter: 1 and 2 stands for RIP version1 and RIP version 2 respectively, 12 stands for
both RIP version 1 and 2.
Default: The default setting is 12, i.e., accept both RIP version 1 and version 2 packets.
Command mode: Interface Mode
15.3.2.2.10 ip rip send version
Command: ip rip send version { 1 | 2 | v2-broadcast }
no ip rip send version
Function: Configure RIP version to send on the interface; the “no ip rip send version
command restores the default setting, enables sending RIP packets on the interface.
Parameter: 1 | 2 are both RIP version numbers; v2-broadcast is broadcast only for RIP-II.
When configured to send RIP-II packets, the interface sends RIP-II packets in multicast by
default, packets are only broadcasted when v2-broadcast is set on the interface.
Default: RIP-II packets are sent by default.
Command mode: Interface Mode
Usage Guide: When configured to send RIP-II packets, the interface sends RIP-II packets