Acer AS8950G manual Bios Setup Utility, Navigating the Bios Utility

System Utilities

BIOS Setup Utility

This utility is a hardware configuration program built into a computer’s BIOS (Basic Input/Output System).

The utility is pre-configured and optimized so most users do not need to run it. If configuration problems occur, the setup utility may need to be run. Refer to Chapter 4, Troubleshooting when a problem arises.

To activate the utility, press F2 during POST (power-on self-test) when prompted at the bottom of screen.

The default parameter of F12 Boot Menu is set to Disabled. To change the boot device without entering BIOS Setup Utility, set the parameter to Enabled.

To change the boot device without entering the BIOS SETUP, press F12 during POST to enter the multi-boot menu.

Navigating the BIOS Utility

Six menu options are:

Information

Main

Security

Boot

Exit

To navigate through the following:

Menu - use the left and right arrow keys Item - use the up and down arrow keys Change parameter value - press F5 or F6. Exit - Press Esc

Load default settings - press F9. Press F10 to save changes and exit BIOS Setup Utility

NOTE: NOTE:

Parameter values can be changed if enclosed in square brackets [ ]. Navigation keys appear at the bottom of the screen. Read parameter help carefully when making changes to parameter values. Parameter help is found in the Item Specific Help area of the screen.

NOTE: NOTE:

System information is subject to specific models.

System Utilities 2-3