Acer G5350 Series manual To set a Supervisor/User password, To change the Supervisor/User password

107

Parameter	Description	Option
Password on	Select Enabled to activate security	Disabled
boot	check during POST.	Enabled
Fixed disk	Sets the control level of the hard disk	Normal
boot sector	drive.	Write Protect
Diskette access	Sets the control level of the floppy	Supervisor
	drive.	Normal

To set a Supervisor/User password

1Use the up/down keys to highlight a password parameter (Supervisor Password or User Password) then press Enter.

A password box will appear.

2Type a password then press Enter.

The password may consist of up to six alphanumeric characters (A-Z, a-z, 0-9).

3Retype the password to verify the first entry then press Enter again.

After setting the password, the system automatically sets the chosen password parameter to Installed.

To change the Supervisor/User password

1Use the up/down keys to highlight either change password parameters (Change Supervisor Password or Change User Password) then press Enter.

2Type the original password then press Enter.

3Type a new password then press Enter.

4Retype the password to verify the first entry then press Enter again.

To remove the User password

1Use the up/down keys to highlight the Clear User Password parameter then press Enter.