Jumpers and Connectors, Jumper and Connector Locations | Acer M11E

1.3Jumpers and Connectors

1.3.1Jumper and Connector Locations

Figure 1-3 and 1-4 shows the jumper locations on the system board.

Figure 1-3 Jumper and Connector Locations with a Network Connector

1-6	User’s Guide

Image 22

Acer M11E manual Jumpers and Connectors, Jumper and Connector Locations

Contents

M11E System Copyright Important Safety Instructions Page Page CD ROM Safety Warning Vii FCC Class B Radio Frequency Interference Statement About this Manual Purpose Manual Structure Conventions Table of Contents Bios Utility Xii Xiii List of Figures Xiv List of Tables Page Features System Board User’s Guide Major Components System Board Layout with Network Connector System Board Layout System Board Layout without Network Connector Jumpers and Connectors Jumper and Connector Locations Blackened pin of a jumper or connector represents pin Jumper Settings Connector Functions JP1 ESD Precautions Installing the Pentium II processor Attaching the Processor Fan Sink Removing tape protector from Fan SInk Locking a Wide Clip End 10 Locking the metal bracket Installing a Pentium II Processor 11 Installing the Pentium II Retention Mechanism 12 Installing the Pentium II Retention Mechanism 13 Installing a Pentium II Processor Removing a Pentium II Processor 14 Securing the Pentium II Processor 16 Removing the Pentium II Processor Memory Upgrade Memory Configurations Installing a Dimm 17 Installing a Dimm Removing a Dimm 18 Removing a Dimm Reconfiguring the System Installing Expansion Cards Installing PCI Cards Installing ISA Cards Bios detects and configures only PnP cards Installing an AGP Card 20 Installing an ISA Card 21 Installing an AGP Card Software Error Messages Error MessagesSystem Error Messages System Board Mmmmssssooo Wxxxx Correcting Error Conditions Page Setup Utility Entering Setup Setup Utility Setup Utility System Information Processor Speed ProcessorInternal Cache Size Floppy Drive B External CacheFloppy Drive a IDE Primary Channel Master Serial Port IDE Secondary Channel SlaveTotal Memory Parallel Port 15 PS/2 Mouse System S/N Product InformationProduct Name Main Board ID DMI Bios Version System Bios VersionMain Board S/N Disk Drives Floppy Drives IDE Drives 2 LS-120 Drive Compatible AsIDE Primary Channel Master IDE Secondary Channel Master IDE Primary Channel SlaveIDE Secondary Channel Slave This parameter specifies the size of your hard disk, in MB Disabled Enhanced IDE Features DMA Transfer Mode Serial Ports 1 Onboard PeripheralsBase Address ∙ 3BCh ∙ 378h ∙ 278h Onboard Device Settings Operation Mode PS/2 Mouse Controller Floppy Disk ControllerIDE Controller USB Host Controller SMBus Interrupt IRQ9 Onboard Ethernet Chip Power Management Mode Power ManagementIDE Hard Disk Standby Timer Modem Ring Indicator Power Switch 4 secSystem Sleep Timer System Wake-up Event Boot Options Boot Sequence Silent Boot Fast BootFirst Hard Disk Drive Boot from LANDesk Service Agent Num Lock After BootConfiguration Table Memory Test Date and Time Date Time Advanced Options Memory/Cache Options External Cache Internal Cache CPU CacheMemory at 15MB-16MB Reserved for 2 PnP/PCI Options Memory Parity ModeFor system board with LAN PCI IRQ Setting For system board without LAN PCI IRQ Sharing VGA Palette Snoop Graphics Aperture Size Reset Resource AssignmentsCPU Frequency Plug and Play OS CPU Multiple Bus FrequencyProcessor Speed To set or change a Password Setup PasswordSystem Security Setup Utility To remove your Setup Password To bypass Setup Password Power-on Password Make sure to set JP3 to 1-2 to enable Power-on password Drive Control Settings Disk Drive Control Load Default Settings Abort Settings Change Exit Setup